Woods SB54S Operator's Manual page 19

1. Place a 4" x 4" block under each end of snow-
blower frame.
NOTE: Block only high enough for the skid shoes
to clear ground.
2. Lower snowblower to sit securely on blocks.
3. Properly secure tractor and release all hydraulic
pressure.
4. Loosen and remove skid shoe mounting bolts (3)
and nuts (31).
5. Remove skid shoe and inspect (4).
6. Adjust skid shoe (4) to provide correct depth of cut.
7. Tighten mounting bolts (3) and nuts (31). Tighten to
specifications given on torque chart.
31. 1/2 NC Lock Nut
Figure 13. Skid Shoe Adjustment
PTO Driveline Guard
The shield must turn freely on PTO shaft. Daily lubrica-
tion of both shield bearings and periodic cleaning will
ensure safe operation of the shield.
If shield is damaged or worn, replace components with
genuine Woods service parts.
Walterscheid Driveline
1. Remove Phillips screw on driveline bell shield.
NOTE: In order to slide new bell over shaft guard,
place bell in water at 180° F or in sun to expand
bell temporarily.
(Rev. 5/19/2011)
MAN0869 (04/13/2011)
3. 1/2 NC x 1" Carriage Bolt
4. Skid Shoe
2. Rotate bell shield until three reliefs align with white
plastic collar.
3. Remove bell housing and shaft.
4. Replace components as needed. Follow steps 1
through 3 in reverse.
Figure 14. Walterscheid Driveline
Comer Driveline
1. Rotate three rectangular plastic pins with a screw
driver 90°.
2. Lift pins out with screw driver.
3. Remove bell housing and shaft.
4. Replace components as needed. Follow steps 1
through 3 in reverse.
DP6
Figure 15. Comer Driveline
Owner Service 19
DP7