Advertisement
Quick Links
BODi rS BD004 Series
Bandwidth-on-Demand Internet
with Reliability and Survivability
Quick Start Guide
For more information or to place an order call
(800) 362-3770
This is a Class A device and is not intended for use in a residential environment.
Important–The compliance information in this document is pending and subject to change.
IMPORTANT
Advertisement
Related Manuals for Patton BODi rS BD004 Series
Summary of Contents for Patton BODi rS BD004 Series
-
Page 1: Quick Start Guide
BODi rS BD004 Series Bandwidth-on-Demand Internet with Reliability and Survivability Quick Start Guide For more information or to place an order call (800) 362-3770 This is a Class A device and is not intended for use in a residential environment. - Page 2 Trademarks statement the far end connection first. The term BODi rS is a trademark of Patton Electronics Company. All other trademarks presented in this document • Do not work on the device or connect or disconnect cables during peri- are the property of their respective owners.
-
Page 3: Customer And Technical Support
7.0 Configuring the BODi rS circuitry. It occurs when electronic printed circuit cards are improperly handled and can result in complete or intermittent failures. Do the follow- Refer to the following manual (available online at www.patton.com/manuals) for detailed information ing to prevent ESD: CAUTION about installing, configuring, operating, and troubleshooting theBODi rS BD004: •... -
Page 4: Before You Begin
WAN connections and switch theWi-Fi AP connections off or on. For more information about configuring these connections, refer to Chapter 3 in the BODi rS 007 and BD004 User Manual: (www.patton.com/manuals/BD007_BD004.pdf). BODi rS BD004 Quick Start Guide BODi rS BD004 Quick Start Guide... -
Page 5: Connecting The Modems
(RJ-45) ® Figure 6. BODi rS interfaces Refer to Chapter 3 in the BODi rS BD007 and BD004 User Manual (www.patton.com/manuals/ Note BD007_BD004.pdf) for information about configuring WAN interfaces via the Web Admin interface. Preparing BODi rS for modem installation Figure 1. - Page 6 2.3 Feed antenna cables 3.0 Mounting the BODi rS After all modems have been connected, feed the antenna cables through the space on the top plate (see Figure 3). Screw the top plate onto the BODi rS. 3.1 Mounting BODi rS in a rack BODi rS can be mounted in a rack using the attachable rack mount ears (see Figure 4).