Advertisement
English
Use
Before first use, the battery must be
charged for at least 16 hours.
• Place the appliance on the charging base
(4) whenever it is not in use.
You may need to charge the appliance
many times initially in order to achieve the
best running time performance.
Charging the battery (fig. B)
Warning! Do not charge the battery at
ambient temperatures below 10°C or above
40°C.
• Make sure that the appliance is switched
off.
The battery will not be charged with the
beater bar/vac On/Off switch (9) in the on
position.
• Place the appliance on the charging base
(4) as shown.
• Plug in the charger. Switch on at the
mains. The charging indicator (5) will be
lit.
• For the first charging, leave the appliance
to charge for at least 16 hours.
While charging, the charger may become
warm. This is normal and does not indicate
a problem.
The appliance can be left connected to the
charger indefinitely. The charging indicator
(5) will be lit as long as the appliance is
connected to the plugged-in charger.
Opening the appliance (fig B, C and D)
• To open the appliance for use, lift it from
the charging base (4) (fig. B).
• Pull back the pivot lock trigger (1) on the
handle and rotate the vacuum head (fig.
C).
• Release the pivot lock trigger (1) to lock
the appliance in any of the three different
working positions a, b and c (fig. D).
Switching on and off (fig. E)
• To switch the appliance on, slide the
beater bar/vac On/ Off switch (9) forward
to position 1 (vacuum only).
• For vacuuming with the beater bar
operation, slide the switch (9) forward to
position 2.
• To switch the appliance off, slide the
switch (9) back to position 0.
Troubleshooting
If the product does not work, check the
following:
• The charger was correctly plugged in for
recharge (it feels slightly warm to the
touch).
• The charger cord is not damaged and is
correctly attached to the base.
• The charger is plugged into a working
electrical outlet.
• Check the On/Off switch is in the off
position in the event that the unit is not
charging.
Cleaning and maintenance
Warning! Regularly clean the filters.
Cleaning the dust container and filters
(fig. F and G)
The filters are reusable and should be
cleaned regularly.
• Press the release latch (3) and open the
container door (2).
-8-
Advertisement
