Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Loadrite LP950
Summary of Contents for Loadrite LP950
- Page 1 LP950 Data Printer OPERATORS MANUAL...
- Page 3 Please note that while every effort has been made to ensure that the data given in this document is accurate, the information, figures, illustrations, tables, specifications, and schematics contained herein are subject to change without notice. Actronic Ltd assumes no liability in connection with the use of any Loadrite branded product. © 2004 ACTRONIC LIMITED...
-
Page 5: Table Of Contents
Contents 1 General Description ........................1 2 Installation...........................2 Printer ............................... 2 Electrical Connection ........................3 Use with Data Capture System....................3 3 Printer Controls and Indicators....................4 Function Of Buttons ........................4 Function Of Indicators ........................4 Paper Roll Replacement ....................... 5 Ribbon Casette Replacement...................... -
Page 7: General Description
The LP950 printer is supplied complete with: • a fully adjustable mounting bracket • a cable which may be plugged between the LP950 and the PRINTER/EDP socket at the rear of the Loadrite Weigh Indicator. • a spare ink-ribbon cartridge... -
Page 8: Installation
LP950 OPERATORS MANUAL 2 Installation Printer The LP950 printer should be installed at the appropriate mounting angle, orientation and location to provide optimal conditions of use by the operator. The following important rules should be observed: 1. The printer should not be located in direct sunlight or near any engine compartments which can become excessively hot. -
Page 9: Electrical Connection
No other connections are required. Connection is made by plugging the cable between the socket located at the rear of the LP950 and the PRINTER/EDP socket located at the rear of the Loadrite Weigh Indicator. The power supply to the printer is switched ON and OFF by the main power ON/OFF switch on the side of the Loadrite indicator. -
Page 10: Printer Controls And Indicators
LP950 OPERATORS MANUAL 3 Printer Controls and Indicators The LP950 printer has two control buttons and three associated indicator lights on the operator control panel. Function Of Buttons Paper Feed This button is used to fast feed the paper out of the printer. It may be used when required during paper loading. -
Page 11: Paper Roll Replacement
Do not pull the paper roll backwards through the printer mechanism as this will cause irrepairable damage! The LP950 printer uses standard 57mm wide paper; either plain or 2-layer NCR - if a duplicate copy is required. The maximum roll diameter in either case is 57mm. -
Page 12: Ribbon Casette Replacement
10. Press the ON LINE button and the printer is now ready for operation. Ribbon Casette Replacement Printing on plain paper in the LP950 printer is achieved by use of an inked ribbon which is contained in a replaceable cassette. -
Page 13: Baud Rate
9600 baud. Earlier printers communicated at the slower speed of 1200 baud. If the LP950 printer is used with an LR810 indicator, the LR810 should have the Baud Rate setting changed to 9600 baud. (Ask your Loadrite dealer for details). -
Page 14: Specifications
LP950 OPERATORS MANUAL 4 Specifications Injection moulded polycarbonate. Case - Silicon rubber 'O' ring sealed. UV resistant polyester front panel membrane pushbuttons. Operating ambient temp. -10°C to +50°C. Environmental - The unit must not be operated in direct sunlight. Relative humidity 20% to 90% Splashproof to IP52 (water from above only). - Page 15 LP950 OPERATORS MANUAL 11.2 to 32V DC. Power Average Current when Printing: Requirements - 0.75A @ 12V DC input 0.4 A @ 24V DC input Peak Current when Printing: 3.0A @ 12V DC input 1.3A @ 24V DC input Standby Current: 100mA max 40mA typ.
- Page 16 LP950 OPERATORS MANUAL Notes...