LOADRITE™ LP950 Printer User Guide CONTENTS General Information ................1 Introduction .................. 1 Printer Controls and Indicators..............2 Function of Buttons..................2 Function of Indicators ................2 Paper Roll Replacement................3 Ribbon Cassette Replacement..............4 Baud Rate....................5 Installation....................6 Printer ......................
This manual covers all models of Loadrite Printers. A detailed description of the 'print-outs' available is given in the Loadrite User Guide. The Loadrite Printer is supplied complete with:...
LOADRITE™ LP950 Printer User Guide PRINTER CONTROLS AND INDICATORS The Loadrite Printer has two control buttons and three associated indicator lights on the operator control panel. FUNCTION OF BUTTONS AND INDICATORS ICON NAME DESCRIPTION The printer can be switched 'ON LINE' and 'OFF LINE' (i.e.
Do not pull the paper roll backwards through the printer mechanism as this will cause irreparable damage! The Loadrite Printer uses standard 57mm wide paper; either plain or 2-layer NCR - if a duplicate copy is required. The maximum roll diameter in either case is 57mm.
10. Press the On Line button and the printer is now ready for operation. RIBBON CASSETTE REPLACEMENT Printing on plain paper in the Loadrite Printer is achieved by use of an inked ribbon which is contained in a replaceable cassette. The ribbon will normally last for 2 to 3 rolls of paper.
If the Loadrite Printer is used with an LR810 indicator, the LR810 should have the Baud Rate setting changed to 9600 baud. (Ask your Loadrite dealer for details). If the Baud Rate of the printer needs to be changed, your Loadrite dealer can provide an instruction sheet.
Connection is made by plugging the cable between the socket located at the rear of the Loadrite Printer and the PRINTER/EDP socket located at the rear of the Loadrite Weigh Indicator. The power supply to the printer is switched On and Off by the main...
USE WITH DATA CAPTURE SYSTEM The Loadrite weighing system may be operated with both an LP950 Printer and a Data Capture System. Please consult your local Loadrite dealer for the supply of the Data Capture System.
LOADRITE™ LP950 Printer User Guide SPECIFICATION Case Injection moulded polycarbonate. Silicon rubber ‘O’ ring sealed. UV resistant polyester front panel membrane push buttons. Environmental Operating ambient temp -10°C to +50°C. The unit must not be operated in direct sunlight. Relative humidity 20% to 90%.
Page 12
LOADRITE™ LP950 Printer User Guide Baud Rate 1200 or 9600 baud set by internal jumper. Data Buffer 1 line (24 character) printing of line initiated when buffer full (24 char.) or LF, CR, CRLF received. CR and LF are treated as a CRLF pair.
Page 13
LOADRITE™ LP950 Printer User Guide Notes...
Page 14
LOADRITE™ LP950 Printer User Guide Notes...
Page 15
LOADRITE™ LP950 Printer User Guide Notes...