Table of Contents
Advertisement
When motion detection is activated, the Motion pop-up window will open.
When motion is detected, the signals will be displayed on the Motion window as shown
below
Motion Detection
Turn motion detection on or off. The default setting is Off.
Motion Detection Setting
In the Motion window the red line provides a motion detection threshold indication; and
the blue line provides a representation of motion being detected. For the camera to
register a motion event, the blue line must move above the red line. After changing any
of these four settings you must click Save to apply the change.
•
Sampling pixel interval [1-10] – Default value is 10, which means system will take
one sampling pixel for every 10 pixels.
•
Detection level [1-100] – Default detection level is 10. This item sets the detection
level for each sampling pixel; the smaller the value, the more sensitive it is.
•
Sensitivity level [1-100] – The default sensitivity level is 80, which means if 20% or
more sampling pixels are detected as changed, the system will detect motion. The
bigger the value, the more sensitive it is. As the sensitivity value is increased, the
red horizontal line in the motion indication window will be lowered accordingly.
•
Time interval (sec) [0-7200] – The default interval is 10. The value is the interval
between each detected motion event.
55
Advertisement
Table of Contents
