Acuralink/Messages; Rear View Camera; Rear View Camera Brightness Adjustment - Acura 2008 TL Navigation System User Manual

Main Menu

AcuraLink/Messages

For complete details on setting up your
AcuraLink messaging, refer to the
AcuraLink section in your Owner's
manual. Or, you can go to the Owner
Link section on the TL page in
www.acura.com.

Rear View Camera

Your vehicle is equipped with a rear
view camera as shown in the
illustration.
Rear View Camera
Whenever you shift to R (Reverse) with
the ignition switch in the ON (II)
position, the rear view is shown on the
navigation system screen. For the best
image, always keep the rear view
camera lens clean, and be sure it is not
covered.
Since the rear view camera display area
is limited, you should always back up
slowly and carefully, and look behind
you for obstacles.
2008 TL
System Set-up
Rear View Camera Brightness
Adjustment
When in reverse, the touch screen, and
Navi "hard" buttons are locked out,
except the ZOOM buttons. Touching
the " " or " " button allows you to
adjust the brightness of the rear view
camera image. This brightness
adjustment is independent of the screen
brightness adjustment in Setup.
NOTE:
• The camera brightness cannot be
adjusted by voice control.
• Slight delays can occur when
switching to the camera image, or
switching back to the map/menu
screen. This is normal.
Navigation System 101