Advertisement
Change equalization mode
1. EQ setting is visible on the 4th LED of the LED tower (in PRIMARY mode)
2. Press EQ MODE button to switch between AUTO and MANUAL cable equalization mode
3. In manual mode use the 30 turn trimpot (EQ LEVEL) to set values between 0 and 40dB,
which helps tweaking the given cable loss even on highest 1080p resolution.
4. Turn the EQ LEVEL trimpot clockwise to increase compensation level
5. Turn the EQ LEVEL trimpot counter-clockwise to decrease compensation level
Connect to the computer
Lightware's Advanced EDID Management is available via USB connection. Please connect
the device by the attached USB Mini-B cable and start Lightware Matrix Control Software to
access advanced settings.
Serial Port
A serial device can be connected to the RS232 port to use the serial data pass-through
function of the RX-TX pairs. This option is useful e.g. to connect touch panel control devices.
Maximum cable length
Resolution
TMDS Freq CAT5e UTP CAT6 UTP CAT6 S/FTP CAT7 S/FTP
640 x 480
25,2 MHz
800 x 600
40,0 MHz
1024 x 768
65,0 MHz
1280 x 720p
74,4 MHz
1920 x 1080i
74,4 MHz
1280 x 1024
108,2 MHz
1920 x1080p
149,1 MHz
1920 x 1200
153,4 MHz
1600 x 1200
162,4 MHz
1920 x 1080p 30 bit 186,3 MHz
1920 x 1080p 36 bit 223,6 MHz
NR: Not Recommended
Info: The unit shows its 3 digit firmware version after powering on with red and green blinks
(FW 1.1.8 is: 1x red, 1x green, 8x green)
www.lightware.eu
For technical support contact support@lightware.eu
65 m
75 m
80 m
80 m
65 m
70 m
75 m
75 m
60 m
65 m
75 m
75 m
60 m
65 m
75 m
75 m
60 m
65 m
75 m
75 m
50 m
65 m
70 m
70 m
30 m
55 m
65 m
65 m
20 m
50 m
65 m
65 m
NR
45 m
65 m
65 m
NR
NR
40 m
60 m
NR
NR
10 m
20 m
Remote power option with Lightware Matrix IO boards
HDMI-TP-RX200R
Quick Start Guide
Firmware version: 1.1.8
Document revision: 1.0
Advertisement
