Lightware HDMI-TP-RX200R Quick Start Manual

Introduction
The HDMI-TP-RX200R is a HDMI 1.3a compatible Twisted Pair receiver. It includes precise
manual, or automatic cable equalizing, which is configurable on the front panel.
Typical application
HDMI-TP-TX and RX200R extender pair
Installation
1. Connect the first display (e.g. monitor) to the HDMI OUT 1 connector,
2. Connect the second display (e.g. projector) to the HDMI OUT 2 connector,
3. Connect the transmitter or a compatible Lightware device
a. VIDEO IN with a Twisted Pair cable
b. DDC IN with another Twisted Pair cable
4. Supply the unit with +12V 1A DC. The available power supply settings:
RX jumper configuration
only local adaptor
local adaptor + remote send to TX
only remote receive from TX
only local adaptor
only remote receive from Output Board
Change status LEDs' function
Press the LEARN button to switch between PRIMARY (SOLID) and SECONDARY (BLINKING)
mode.
1
Please check the TP Extension System Cross Compatibility Table in the
www.lightware.eu
For technical support contact support@lightware.eu
1
to the
TX jumper or Matrix Output Board configuration
only local adaptor
only remote receive from RX
local adaptor + remote send to RX
12V DC IN not connected to Output Board
12V DC IN connected to Output Board
www.lightware.eu website
Status LEDs in PRIMARY (SOLID) mode
Color Function:
Red HDCP ENCRYPTED CONTENT
Green HDMI SIGNAL
Green VIDEO CLOCK PRESENT
Green AUTO CABLE EQUALIZATION ACTIVE
Status LEDs in SECONDARY (BLINKING) mode
Color Function:
Red blinking EMULATED EDID INVALID
Green blinking EMULATED EDID VALID
Green blinking OUT1 MONITOR HOTPLUG SENSE
Green blinking OUT2 MONITOR HOTPLUG SENSE
Selecting an EDID
1. Turn the EDID address rotary switch to the desired memory.
2. The available EDIDs are listed on the top of the device.
3. The EDID Status LEDs provide feedback in SECONDARY (BLINKING) mode:
Red blinking: an empty memory or invalid EDID was selected.
Green blinking: valid EDID is present at input.
4. Now the selected EDID is reported on the DDC INPUT.
EDID Memory
The available EDIDs are listed on the top of the device (#0..#9).
▪ Address #0 contains a copy of the last recognized monitor's EDID from HDMI OUT 1.
▪ On the address #1 there is an UNIVERSAL EDID to support various resolutions and
embedded HDMI audio.
▪ Memory range #2..#8 is user programmable.
▪ Address #9 contains a copy of the last recognized monitor's EDID from HDMI OUT 2.
Learning EDID
1. Turn the Rotary switch to the desired memory address where you want to store the attached
display's EDID (between user addresses #2..#8),
2. Connect the desired display device to the HDMI OUT 1.
3. Press and hold the LEARN button for approximately 2 seconds,
4. The EDID Status LEDs provide feedback in SECONDARY (BLINKING) mode:
Red blinking: the learn process failed from HDMI OUT 1.
Green blinking: the learn process was successful from HDMI OUT 1.
Info: Without the Lightware Matrix Controller SW the TX200R can learn only from HDMI OUT 1.
HDMI-TP-RX200R
Quick Start Guide
Firmware version: 1.1.8
Document revision: 1.0