Viking Designer Series Installation Manual
Undercounter trash compactor
Hide thumbs
Also See for Designer Series:
- Manual (47 pages) ,
- Installation manual (16 pages) ,
- Instructions manual (8 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for Viking Designer Series
Summary of Contents for Viking Designer Series
- Page 1 Viking Installation Guide Viking Range Corporation 111 Front Street Greenwood, Mississippi 38930 USA (662) 455-1200 For product information, call 1-888-VIKING1 (845-4641) or visit the Viking Web site at vikingrange.com Designer Series Undercounter Trash Compactor F20178I EN (061109J)
-
Page 2: Important - Please Read And Follow
(87.0 cm) underneath 6” (15.2 cm) 24” Min. • Viking Range Corporation will NOT warranty any problems resulting from GFI outlets which are not installed properly or do not side of clearance (61.0 cm) meet the requirements below. countertop right side of Min. -
Page 3: Installation
CUSTOM FRONT PANEL INSTALLATION (DFC MODELS) INSTALLATION Begin with compactor in room where it will be installed. The Designer Full Overlay model should be installed with a locally supplied custom front panel. All parts needed to install the panel come standard with the Designer Full Overlay model trash compactor. A handle should be used on the custom front panel rather than a knob because a knob does not provide enough grip. -
Page 4: Completing Installation
INSTALLING CUSTOM FRONT (DFC MODELS ONLY) COMPLETING INSTALLATION 1. Prepare custom front panel and handle. (See information on p. 4 for details/dimensions.) CAUTION: FLOOR DAMAGE 2. Placed prepared custom front panel on the ledge of the unit. (See Illustration #1). WARNING: PERSONAL INJURY HAZARD 3. - Page 5 ADJUSTING TOE PLATE If the toe plate rubs the floor covering, the toe plate clearance may be changed as follows: 1. Mark on each side of the toe plate the amount of toe plate that rubs the floor. 2. Fully open compactor drawer. Remove drawer retaining screws from track assembly on each side ofdrawer.