Main Drive Gear Assembly; Washout Assembly - THUNDER TIGER Raptor 30 V2 User Manual

4 Main Drive Gear Assembly

(1) HMC3-12B Socket Screw (M3x12).......... 4
(2) HMQ14 Snap Ring.................................... 2
(3) BV0033 One Way Clutch Housing.............1
(4) BK0031 Main Spur Gear........................... 1
(5) BK0032 Tail Drive Pulley........................... 1
(6) BK0034 One Way Clutch Shaft..................1
Add a drop of Blue Locktite on the
thread of each of these four screws.

5 Washout Assembly

(1) HMJ2-10N Self Tapping Screw(M2x10).. 2
(2) HMC3-10B Socket Screw (M3x10)......... 2
(3) HMV740ZZ Bearing (d4xD7xW2.5)........ 4
(4) BK0077 Collar ........................................ 2
(5) BK0079 Pin............................................. 2
(6) BK0075 Linkage Ball.............................. 2
(7) BK0015 Flybar Control Lever.................. 2
(8) BK0016 Washout Linkage ..................... 2
(9) BK0014 Washout Base............................1
Make sure Linkage Balls are attached to the
inside hole of each stabilizer control lever.
(1) HMJ2-10N
(3) HMV740ZZ
(8) BK0016
(5) BK0079
(2) HMC3-10B
For sport kit (29BB) version, (3) will be replaced by Bushing(BK0107x4)
(4) BK0031
(5) BK0032
(2) HMQ14
(3) HMV740ZZ
(4) BK0077
(4) BK0077
(3) HMV740ZZ
(7) BK0015
(6) BK0075
(3) HMV740ZZ
(9) BK0014
(1) HMJ2-10N
(6) BK0075
(7) BK0015
7
(2) HMQ14
(3) BV0033
(1) HMC3-12B
(6) BK0034
(2) HMC3-10B
(5) BK0079
(8) BK0016