Attaching The Nose Pad; Attaching The 3D Glasses Band; Using The 3D Glasses; Turn On/Off The Power - Sharp LC-60LE925X Operation Manual

Enjoying 3D image viewing

Attaching the nose pad

Attach either of the supplied nose pads as needed (such
as when the glasses do not fi t properly). The glasses
come with a large and small nose pad.
 Attaching the
nose pad

Attaching the 3D glasses band

Attach the supplied 3D glasses band strap as needed
(such as when the glasses do not fi t properly). Insert
the ends of the 3D glasses into the 3D glasses band
until they are secure.
• Pull the cord stopper on the strap to adjust the strap
length.
 Removing the
nose pad

Using the 3D glasses

Turn on/off the power

Turn on the power of the 3D glasses.
1
• Press the power button for at least two seconds.
• The LED light blinks three times.
Turn off the power of the 3D glasses.
2
• Press the power button for at least two seconds.
• The LED light lights for two seconds.
NOTE
• When the battery power is low, the LED light blinks six
times after the power is turned on.

Switching between 2D and 3D modes

When viewing 3D images, you can press the power
button to switch between 2D and 3D modes. This is
useful when several people are viewing 3D images on
the same TV with some people wanting to watch in 3D
and some people wanting to watch in 2D.
E Viewing 2D images
When you press the power button twice while viewing 3D
images, the LED light blinks two times and the 3D images
switch to 2D images.
E Viewing 3D images
When you press the power button twice while viewing 2D
images, the LED light blinks three times and the 2D images
switch to 3D images.

Angle of the 3D glasses

The 3D glasses can be used by receiving an infrared
signal sent from the TV.
The 3D glasses turn off automatically after three
minutes if no signal is received from the TV.
Operating range
From directly in front of the infrared transmitter on
the TV: approx. 5 m (within approx. 30° horizontally
and 20° vertically)
NOTE
• The infrared emitter lights in 3D mode.
51