Capstan Cover; Reel Motor - Sony DVCAM DSR-250 Service Manual

2-3-3.

CAPSTAN COVER

Disassembly/Assembly
Tightening torque of capstan cover
Screw
0.3432 ± 0.0196 N • m (3.5 ± 0.2 kg • cm)
Capstan cover
2
2-3-5. FL MOTOR ASSEMBLY, GEAR A, GEAR B AND GEAR CD ASSEMBLY
Disassembly/Assembly
FL motor assembly
Claw
Pass the two flexible boards
1
of the drum assembly through
the hole.
Insert the claw into the long hole
of the chassis and fix the cover
with the screw.
Positioning bosses
Gear CD assembly
Gear A
Gear B
Hole
C
Hole
D
Hole
B
2-3-4.

REEL MOTOR

Disassembly/Assembly
Do not fasten
this screw.
After inserting the flexible board
of the reel motor into CN3, attach
the reel motor and lock CN3.
Remove the claws of the FL motor assembly from hole A and hole
B and remove the FL motor assembly. Then, remove each gear, etc.
To attach them, after attaching the gears, etc. to the FL motor assembly
and hook the positioning bosses of the FL motor block on holes C
and D then fit the two claws in each hole A and B .
Apply grease
(half size of one grain of rice).
Hole
A
5-39
Tightening torque of reel motor
0.0686 ± 0.0098 N • m (0.7 ± 0.1 kg • cm)
Fasten the screws
Screw
1
in order of
Screw
2
Screw
Reel motor
CN 3
The worm gears are attached inside the
FL motor assembly. When attaching the FL
motor assembly, apply grease there.
, , .
1 2 3
3