Sony DVCAM DSR-250 Service Manual page 114

1-4. Replacement of Outside Holder T and Eyepiece Outer Ring
1-4. Replacement of Outside Holder T
and Eyepiece Outer Ring
1. Remove the outside holder T referring to Section 1-2-
2. "Replacement of CRT/DY assembly".
2. Push two pins to portion A by slotted screwdriver as
shown in figure.
A
Pin
Slotted screwdriver
Outside holder T
3. Remove a screw, washer and two hinge springs. Then,
remove the outside holder T and eypiece outer ring as
shown in figure arrow.
Outerside holder T
Screw
1-4 (E)
Pin
Eyepiece outer ring
Hinge springs
4. Pull out two pins.
Pin
5. Replace outside holder T or eyepiece outer ring to new
one. Insert two pins to portion B by slotted screwdriver
as shown in figure.
Pin
Pin
Pin
B
Pin
DXF-801/801CE