Basic Operation - Ematic ED929D User Manual

The Use of Remote Control
Please put the battery into the remote control as per illustration below .
1
CR2025
When using remote control, make sure the infrared window is pointed to infrared
receiving window of the unit. The distance between the unit and remote control must be
within 3 metres. Please refer to the following illustration.
Unit A
Remote Control A
ED929D A
Note:
1. To avoid falling off or place near damp environment.
2. To avoid infrared receiving window of the unit being under direct sunlight.
3. Please use a new battery to replace old one if the remote control doesn't work.
4. Remote control A can only operate unit A, Remote control B can only operate unit B.
2
CR2025
Unit B
Remote Control B
ED929D B
10

Basic Operation

DVD
MPEG4 SVCD VCD CD
Playing disc of DVD, MPEG4, SVCD, VCD, CD, MP3.
1. In the Source Mode,you can press
source you want.
DVD
2. Open the disc door and insert a disc into the door with the label side facing up.
3. Close the disc door.The unit will load the disc and start playing.
4. Press" "once to stop playback; press"
where you stopped;press" "twice to stop playback completely.
5. During playback,press" "to pause; press it again to resume playback.
6. When the playing is finished, please turn off the power by sliding ON/OFF switch to OFF.
7. For some DVD disc with Title or Chapter menu, press"MENU"button to enter menu
page, and use" "to select. Press ENTER to confirm.
Note:
Please do not disconnect USB devices or plug out SD/MMC cards while they are working
with the unit.Functional failure may occur in case of wrong operations.
Play/pause
ED929D A
MP3
" " to select and ENTER key to enter the " "
SD USB
"to resume playback from the point
Title
Cursor button
ENTER
ED929D
11
Menu
A