Table of Contents
Advertisement
About the side cable access hole
If you choose not to drill hole in the wall or
ceiling, but to wire the camera with the cable
exposed, cut the cable access hole on the side
of the dome cover to provide a cable entry.
Precautions when wiring from the side:
• Remove the dust guard cap. Run the cable
through the cable access hole and bend it
inward, then reinstall the dust guard cap.
• Move the cable to one side as shown.
• Be careful not to pinch the cable with the
dome cover.
Installation method of camera
Using a gang junction box
(locally procured)
When using a gang junction box (101.6 mm x
60.3 mm), procure one locally that meets the
dimensions in the figure.
Next locally procure 2 camera-mounting screws
suitable for the installation surface and structure
of the wall/ceiling or gang junction box.
1 Attach the gang junction box to the wall or
ceiling.
2 Attach the camera to the gang junction box
with the 2 screws (locally procured).
3 Tighten all mounting screws.
14
Side cable
access hole
Installation mark
Screws
(M4, locally procured)
83.5 mm
Gang junction box
(locally procured)
Advertisement
Table of Contents
