Table of Contents
Advertisement
Available languages
Available languages
ELECTRIC COOKTOP INSTALLATION INSTRUCTIONS
Cooktop Installation
These cooktops are designed to fit various cutout sizes.
The minimum and maximum cutout openings are shown
in Figure 1.
Secure the Unit
Unit Clamp Down Information
Once the cooktop is installed and centered in the
counter opening, you must clamp the unit down as
shown.
To clamp down, insert the offset side of the angle
bracket into the slots on each side of the unit. Then run
the thumb screw through the bracket, up against the
bottom of the counter. Tighten until the unit draws down
(figure 5).
Cooktop
Angle Bracket
Burner Box
Figure 5
Countertop
Screw
5
Checking Operation
Refer to the Use and Care Guide for operation.
Do not touch cooktop glass or elements.
CAUTION
They may be hot enough to burn you.
Model and Serial Number Location
The serial plate is located under the cooktop or in the
burner box and can be seen by lifting up the main top of
unit.
When ordering parts for or making inquires about your
cooktop, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate
on your cooktop.
Before You Call for Service
Read the Before You Call for Service Checklist and
operating instructions in your Use and Care Guide. It
may save you time and expense. The list includes
common occurrences that are not the result of defective
workmanship or materials in this appliance.
Refer to your Use and Care Guide for Sears service
phone numbers, or call 1-800-4-MY-HOME
if you have inquiries about your product and/or need to
order parts.
®
. Please call
Advertisement
Table of Contents
