Vicovation Vico-Marcus 3 Installation Manual

Thank you for choosing Vico-Marcus 3 Extreme HD Car There's one quick mounting bracket in Marcus 3 Box.
Please check the following steps to reconnect quick mounting bracket with
Camcorder. Please follow the installation guide for more detail
suction bracket.
when using Vico-Marcus 3, and notice our highlight parts as
Note: Marcus Quick mounting bracket is compatible with standard 52mm
important reminders.
CPL filter to reduce reflection effect from windshield, getting more saturated
and beautiful video.
1.CPL filter is optional accessory, not including in box. Users can choose
Marcus CPL filter or any 52mm standard CPL filter.
2.CPL filter will lower a little bit brightness of image. Please adjust it
especially for night-time record. You can 1. Adjust CPL angle. 2. Set EV
value. 3. Or you may Disassemble CPL filter at night.
Vico-Marcus3 equipped with Quick mounting bracket module, you may switch
it into Suction bracket or Sticker bracket. We listed 2 ways of installation below
with Suction bracket integrated type.
Users may choose by their preference. Install bracket in the proper position on
windshield and avoid any view-blocking.
Please loosening the cap
nut on Ball Head of
Suction bracket first, and
pull out T-type ball head.
Please notice that the direction of Suction handle faces forward the
windshield.
Insert Quick mounting
back into notches.
Please notice the cap
nut needs to be placed
on ball head firstly. And
properly fasten the cap
nut after you put on
Marcus 3.
Please notice that the direction of Suction handle faces upper side.
1.Insert Micro SD card firstly.
1.Always use original VicoVation USB Cigar Car charger in box.
2.Install USB Cigar charger into car cigarette Lighters socket, and (Please aware the direction of Micro SD
another USB side insert into Vico-Marcus 3 USB socket.
card data pins.)
3.Install bracket in proper position on windshield and avoid any
2. Marcus 3 support Extreme HD 1296p
view-blocking for driver.
and High Speed Full HD 1080p 60fps
recording. Micro SD card under Class10
is forbidden.
1296p 30fps
8GB 45 mins
16GB
105 mins
32GB 222 mins
How to embed the cable easily by yourself: Cable can go through sunshade
64GB 460 mins
board, along with door rubber sealing on one side of front pillar (A pillar),
Video Bit Rate 18Mb/s
and then beneath the carpet of front passenger seat. (You may need special
2.After power on, device will boot up and enter into recording mode.
tool for wiring under rubber sealing or professional assistance.)
3-second recording period is protected from stopping. To enter MENU is not
limited by these 3 seconds.
3.Please setup system time and format Micro SD card manually for the first
time operation.
4.To remove Micro SD card, please stop recording or power off firstly to
protect recording data.
5.Please use Micro SD card (SDHC/SDXC) with level Class10 only.
Best Area
Mars3 V1.0
Special Notice:
1.Vico-Marcus 3 applies unique designed Marcus car charger for auto
boot up. Please apply only VicoVation Marcus car charger to avoid any
damage.
2.Please notice that Marcus car charger is a unique design for Marcus
Marcus 3 uses standard Micro SD card slot format.
Special Note:
Marcus 3 becomes card reader (Slave device) in connection with PC by USB
1.If there is safety airbag inside your car front pillar, please ask for
professional assistance. Try not to embed the cable on your own. cable. To operate Marcus 3, please connect it with cigar car charger or USB
2.Please restore the rubber sealing after embedding power cable.
power adaptor.
Micro SD
Red dot recording sign/
Current Time/
Recording Size/
G-Sensor function sign/
1080p 60fps 1080p 30fps 720p 60fps 720p 30fps
Emerg. Rec. Numbers.
45 mins 75 mins 100 mins 180 mins
105 mins 166 mins 215 mins 375 mins
222 mins 347 mins 445 mins 765 mins
460 mins 710 mins 910 mins 1545 mins
18Mb/s 12Mb/s 9Mb/s 6Mb/s Emergency record/
The initial
Recording sign/
Menu/
Voice recording/ mute switch
Power ON/Off
Mars3 V1.0
5/10
Set video resolution and EV value. 1080p 30fps is recommended.
Setup sensibility of G-Sensor (Default setting is OFF).
5/10
To activate this function, please install Marcus GPS Mouse (Optional) and
plug the GPS socket properly. (If GPS module doesn't be installed
properly, the settings won't be able to enter.)
1. GPS relative function can be only activated
while GPS installed correctly. GPS function
menu can be entered after GPS antenna receive
GPS signal.
2. After booting, GPS function will be activated
after GPS signal received.
After successful GPS positioning, a Blue Arrow will pop out at the top of
display to confirm GPS features are activated.
When current speed reach your setting value (For example: 60km/h), Marcus 1
will notify drivers with Beep sound and alert Icon while lane departure.
When current speed over 60km/h, Marcus 1 will notify drivers with Beep sounds
and alert Icon if distance between car in front reaches 5~7 meters.