Vicovation Vico-Marcus 1 Installation Manual

Vico-Marcus 1 Installation Guide Marcus Quick Mounting Bracket Installation
Thank you for choosing Vico-Marcus 1 1080p Full HD Car There's one quick mounting bracket in Marcus1 Box.
Please check the following steps to reconnect quick mounting bracket with
Camcorder. Please follow the installation guide for more detail
suction bracket.
when using Vico-Marcus 1, and notice our highlight parts as
Note: Marcus Quick mounting bracket is compatible with standard 52mm
important reminders.
CPL filter to reduce reflection effect from windshield, getting more saturated
and beautiful video.
Vico-Marcus 1 Outlook Introduction:
1. Power button 9. External GPS socket
2. Down / Mute 10. Speaker
3. Up / MENU 11. Microphone
4. Start/Stop record/Confirm 12. 2.0" TFT LCD Display
5. Emergency Record / Return 13. LED indicator (Red=Recording,
6. Micro SD card slot Green=Stand by, Red Flashing=No SD Card)
7. USB / Power socket 14. Bracket socket
8. HDMI output 15. Mega Pixel Lens
Vico-Marcus 1 Standard accessories:
Quick mounting 4m USB
Marcus 1 Suction Bracket
bracket cigar car charger
Special Note:
1.CPL filter is optional accessory, not including in box. Users can choose
Marcus CPL filter or any 52mm standard CPL filter.
2.CPL filter will lower a little bit brightness of image. Please adjust it especially
for night-time record. You can 1. Adjust CPL angle. 2. Set EV value. 3. Or you
Installation guide Warranty card may Disassemble CPL filter at night.
Suction Bracket & Quick mounting bracket
Vico-Marcus 1 equipped with Quick mounting bracket module, you may
switch it into Suction bracket or Sticker bracket (Optional). We listed 2
ways of installation below with Suction bracket integrated type.
Users may choose by their preference. Install bracket in the proper
position on windshield and avoid any view-blocking.
Please loosening the
cap nut on Ball Head of
Suction bracket first,
and pull out T-type ball
head.
▲Type A: Marcus 1 + Standard Suction Bracket
Please notice that the direction of Suction handle faces forward the
windshield.
Insert Quick mounting
back into notches.
Please notice the cap
nut needs to be placed
on ball head firstly. And
properly fasten the cap
nut after you put on
Marcus 1.
▲Type B: Marcus 1 + Quick mounting bracket + Suction Bracket
Please notice that the direction of Suction handle faces upper side.
First time installation
(Optional) 3M Sticker Bracket & Quick mounting bracket Installation
3M Sticker bracket is optional accessory. Please contact VicoVation or 1.Always use original VicoVation USB Cigar Car charger in box.
2.Install USB Cigar charger into car cigarette Lighters socket, and another
authorized reseller to purchase if needed.
USB side insert into Vico-Marcus 1 USB socket.
3.Install bracket in proper position on windshield and avoid any
view-blocking for driver.
DIY Installation and wiring
How to embed the cable easily by yourself: Cable can go through sunshade
board, along with door rubber sealing on one side of front pillar (A pillar),
and then beneath the carpet of front passenger seat. (You may need special
tool for wiring under rubber sealing or professional assistance.)
▲Type C: Marcus 1 + 3M sticker Bracket
Special Notice:
1.Vico-Marcus 1 applies unique designed Marcus car charger for auto boot up.
Please apply only VicoVation Marcus car charger to avoid any damage.
2.Please notice that Marcus car charger is a unique design for Marcus series only,
which can NOT be used on other VicoVation products.
Special Note:
▲Type D: Marcus 1+ Quick Mounting Bracket + 3M Sticker 1.If there is safety airbag inside your car front pillar, please ask for professional
assistance. Try not to embed the cable on your own.
Bracket
2.Please restore the rubber sealing after embedding power cable.
First time operation
1.Insert Micro SD card firstly. (Please aware the direction of Micro
SD card data pins.)
Micro SD
Normal Recording Time Table (Not including 15 sets Emergency Record):
1080p 30fps 720p 30fps
8GB 75 mins 121 mins
16GB 166 mins 260 mins
32GB 347 mins 530 mins
Video Bit Rate 12Mb/s 8Mb/s
2.After power on, device will boot up and enter into recording mode. The initial
3-second recording period is protected from stopping. To enter MENU is not limited
by these 3 seconds.
3.Please setup system time and format Micro SD card manually for the first time
operation.
4.To remove Micro SD card, please stop recording or power off firstly to protect
recording data.
5.Please use Micro SD card (SDHC) with level Class10 only.
Best Area
Note:
Marcus 1 uses standard Micro SD card slot format.
Marcus 1 becomes card reader (Slave device) in connection with PC by USB cable. To
operate Marcus1, please connect it with cigar car charger or USB power adaptor.
Main Display
Recording:
1.Under normal recording, icons
represent (From upper left side):
Red dot recording sign/
Current Time/
Recording Size/
G-Sensor function sign/
Emerg. Rec. Numbers.
2.Icons in bottom side:
Emergency record/
Recording sign/
Menu/
Voice recording/ mute switch
Power ON/Off
User Interface:
1.Video settings
2.Function Settings
3.Display settings
4.Audio settings
5.Playback settings
6.System settings.