Advertisement
water tank and fit into position in the
recess.
6 Fill the tank with the desired amount of
water. The water must be between the
top and bottom cup marks. Do not fill
above the MAX level. (Alternatively fill
the water tank when fitted inside the
coffee maker but take care not to
cause spillage.)
G Use cold water. We recommend using
filtered water from a Espressione Water
Filter as it reduces limescale. Never
use warm or fizzy water.
7 Replace the water tank back into the
coffee maker.
8 Ensure the filter holder is in position in
the coffee maker.
9 Fit either the permanent filter supplied
or a paper filter into the filter holder.
Add the coffee, use the spoon provided
(approximately 1 level spoon per cup or
to taste).
10 Close the lid and adjust the aroma
control as required. Turn the control to
the left for stronger coffee and to the
right for weaker coffee.
11 Put the carafe on the hotplate.
12 Plug into the power supply and press
the on/off button.
13 Press the on/off button twice to start
brewing immediately. The on/off button
will glow and the coffee maker will start
to operate. The back light of the display
will come on and automatically switch
off after 10 minutes.
To stop the brewing process at any
time, press the on/off button. The back
light of the display will come on for one
minute and then go off automatically.
14 Don't remove the carafe until brewing
has finished.
G The hot plate will keep your coffee hot,
but the sooner you drink it, the better it
will taste.
G Your coffee maker will keep the coffee
warm and then automatically switch off
after 2 hours. To manually switch off
earlier, press the on/off button..
G As soon as all the coffee has brewed,
switch off and unplug the machine.
G If you haven't used the machine for a
while, run one lot of water through it
(without coffee) to clean it out. Fill the
water tank to the top cup mark when
you do this.
G Never put the carafe in the microwave.
to set the clock
1 Plug in the coffee maker, the backlight
will come on and the display will flash.
2 Select the correct time of day by
pressing the clock button once and the
time will advance by 1 minute. Press
and hold down the button and the time
will advance in 15 minute intervals.
G If required, press the program button
once to change between the 12 and
24 hour clock.
3 To set the clock press the on/off button
or wait 1 minute for it to automatically
set.
G To re-adjust the clock at any time,
press and hold the clock button for 5
seconds and adjust the clock as
above.
Note – the backlight of the display will
automatically turn off after 1 minute.
to program automatic brew
1 Set the clock to the correct time (see
'to set the clock').
2 Press the program button, the clock
symbol and the display will flash.
3 Press the clock button until the desired
brewing time is displayed (follow
procedure in 'to set the clock').
4 Press the on/off button to confirm the
automatic time selected. (The display
panel and the on/off indicator light will
flash).
5 Press the program button to return to
the current time of day (the on/off
button will continue to flash). The
brewing cycle will begin once the set
time is reached and the on/off button
will stop flashing.
G If you want to check the automatic time
selected, press the program button.
G To override the automatic brewing
operation press the on/off button and
the coffee maker will start immediately.
Press the button again to switch off.
4
Advertisement
