Table of Contents
Advertisement
Contact Tech Support at 1.800.215.7015 or email at support@unidencellular.com
QuiCk inStall OVerVieW
1. uniden booster - Select location
Install the Uniden Booster in an area that is protected from the weather, properly
ventilated and is away from excessive heat and moisture.
2. donor (Outdoor) antenna - Select location
The ideal location for the outdoor antenna is on the roof of the building or
a mast structure. The antenna should be placed in a manner that allows it to
capture the best possible cellular signal.
3. Outdoor Coaxial Cable - Select location
Connect the outdoor coaxial cable to the connection on the back of the outdoor
antenna and run the cable to the Uniden Booster and attach it to the connector
labelled "outdoor" on the Uniden Booster.
4. indoor Coaxial Cable - (if used)
Connect the indoor coaxial cable to the connector labelled "indoor" on the
Uniden Booster. Run the cable to the location of your indoor antenna and attach
it to the connector on the back of the indoor antenna.
5. indoor antenna
The ideal location for the indoor antenna will be the area of your property where
you need to improve the signal most.
note: The signal strength will be strongest closest to the antenna.
Whip Antenna - connect the whip antenna directly to the Uniden Booster to the
connector labelled "indoor".
Panel or Dome Antenna - mount to wall or ceiling in your selected location and
attach to coaxial cable that is connected to the Uniden Booster.
6. lightning Surge Protector - (sold separately)
The lightning surge protector connects in between the outdoor antenna and
the Uniden Booster. The lightning surge protector can be installed indoors or
outdoors. When connecting outdoors, install the lightning surge protector inline
between the outdoor antenna and the outdoor coaxial cable. When connecting
indoors, install the lightning surge protector inline between the outdoor coaxial
cable and the Uniden Booster.
7. Commissioning the System
A. Before powering up the Uniden Booster, be sure that all connections are tight
and confirm the power adapter is connected to the AC 110 volt line.
B. Power on the Uniden Booster by connecting the power adapter to the device.
C. Check the status of the alarm LED lights and be sure they are all green.
The gain control dip switches on the Uniden Booster are set in the off position
when shipped, please refer to the instruction manual for more detailed
instructions to attenuate your Uniden Booster.
8
Hide quick links:
Advertisement
Table of Contents
