Removing The Oxy-Pilot Assembly; Replacing The Control Cable - Kohlangaz Gosford Installation And Maintenance Instructions Manual

Inset live fuel-effect gas fires

Table of Contents

4.7.2

Replace in the reverse order using a 1.5V AA Alkaline Battery.

4.8

Removing the Oxy-Pilot Assembly

Note: Because this appliance is fitted with an atmosphere sensing 'Oxy-

Pilot' it is not possible to replace the thermocouple separately, because the

thermocouple position is factory set to a tight tolerance. Any replacement of

parts on the pilot requires a complete new pilot assembly.

4.8.1

Remove the burner assembly as in section 4.1

4.8.2

Unscrew and remove the thermocouple retaining nut from the end of the

control tap, disconnect the ignition lead from the pilot electrode and the

two inline leads from the microswitch.

4.8.3

Unscrew and remove the two pozi-drive screws which secure the pilot

assembly to the burner. Remove the pilot.

4.8.4

Re-assemble in reverse order and carry out a gas tightness test.

4.9

4.9.1

The control lever operating cable can be seen running across the base

of the fire, below the burner. To release the cable, unscrew the cable

securing screw located in the centre of the aluminium operating arm

and pull the cable out from its fixing hole. Release the other end of the

cable by pushing the cable towards the right i.e. into the operating arm

so as to release the tension. Pull the cable nipple out of the retaining

hole and remove the cable through the slot in the operating arm. See

figure 18 below.

Fig. 18

Table of Contents

Show Quick Links

Table of Contents