Table of Contents
Advertisement
• Tire Pressure:
• Please take special note that the tires installed on the bike out of the box only require 65 PSI
rather than the 100 PSI as noted on the tire. If you have any question,s please contact
customer service.
• Crank width adaptor installation will space out the handpedals to allow more
clearance if needed. They add 1.5" per side.
• Use a 15mm open end wrench to remove the handpedal.
• The crank width adaptor with the groove is installed on the right. Remember that the left
side will tighten to the left as it has opposite threads.
• Thread the crank width adaptor onto the handpedal and tighten then thread the pedal and
adaptor onto the crank arm assembly. Tighten down with 15MM open end wrench. Repeat
on the other side. Make sure it is tight.
Special Notes
Advertisement
Table of Contents
