Introduction; Model Descriptions; Installation - Telecast Viper II TR5900 User Manual

Introduction

The Telecast TR5950 is designed for high speed and long distance transport of gigabit Ethernet
data. This unit supports features an RJ-45 jack and an ST or SC type fiber optic connector. The
module also features auto-negotiation support allowing operation in ether full or half duplex mode.
This module can be used as a standalone unit or in a Viper2 Frame.

Model Descriptions

Part Number
MTR5900-A Stand Alone
MTR5900-E Stand Alone
MTR5900-AA Stand Alone
MTR5900-EE Stand Alone
Omit "M" prefix for Rack Mount versions
Same part numbering conventions for 5950 modules
CWDM wavelengths and DFB are optional. Contact Telecast for pricing and availability

Installation

As a standalone unit:
1. Verify the DC power adapter conforms to your local AC power requirements before making your
power connections
2. Required DC power is 12V at 1 Amp with a 2.5mm jack, center pin positive.
3. Make your fiber and UTP (Universal Twisted Pair CAT-5 or better) and fiber Connections
For a Rack mount unit:
1. Carefully slide the module into the Viper2 frame. The power connector is located on the rear rail
of the frame.
2. Connect the UTP media cable for network connection and connect the fiber or fibers
3. Turn on the converter rack power, the power LED will light up
Note: Unlike other Viper2 Modules, Ethernet modules can not be converted from rack to throw-
down or throw down to rack due to the LED indicators and how they are wired for each
configuration.
TYPE Fibers/Conns
1 - SC
1 - SC
2 – ST (or SC)
2 – ST (or SC)
OPTICAL POWER
-8 dBm typical
-8 dBm typical
-8 dBm typical
-8 dBm typical
WAVELENGTH
1310 TX / 1550 RX
1550 TX/ /1310 RX
1310 TX and RX
1550 TX and RX
5