Summary of Contents for Telecast Viper II TR5900
-
Page 1: User Manual
Viper II TR5900 & TR5950 10/100 Ethernet and Gigabit Ethernet Media Converters User Manual Telecast Fiber Systems, Inc. 102 Grove Street Worcester, MA 01605 Tel: 508-754-4858 Fax: 508-752-1520 www.telecast-fiber.com... -
Page 3: Table Of Contents
Table of Contents Laser Safety FCC Part A Manual Notice Warning CE Introduction Model Descriptions Installation LED Indications Mode Description Specifications Warranty... -
Page 4: Laser Safety
Do not allow powered modules of the same link to come into physical contact Telecast 5950’s are designed for long distance connections using a pair of two modules, isolated electrically. Touching the powered ends two modules at the same time may result in an electrical... -
Page 5: Introduction
Introduction The Telecast TR5950 is designed for high speed and long distance transport of gigabit Ethernet data. This unit supports features an RJ-45 jack and an ST or SC type fiber optic connector. The module also features auto-negotiation support allowing operation in ether full or half duplex mode. -
Page 6: Led Indications
TR5900/5950 Connections Fiber port Attach the fiber cable. The Tx, Rx fiber cable must be paired at both ends. Singlemode fiber is recommended for 5950 Default: full duplex mode UTP port Attach Universal twisted pair (UTP) cat-5 cable to RJ-45 port Note for TP port cable connection: 1. -
Page 7: Mode Description
Rack Mount Faceplate indications Telecast Telecast FIBER DATA TX DATA FIBER FIBER LINK LINK FULL DUPLEX DATA RX DATA TX UTP 1000 DATA RX POWER POWER TR5950 TR5900 GIGABIT 10/100Base ETHERNET ETHERNET Mode Description (Model 5950 ONLY) Standard (S) and Legacy (L) mode selection... - Page 8 A note about Legacy and Standard modes: Modules come configured in STANDARD Mode. Older Gigabit Ethernet modules used the Marvell ALASKA chipset. This chipset implemented 1000Base-X without clock information and auto negotiation that is available on newer chipsets. The switch changes internal settings to disable the clock and auto-negotiation parts of the gigabit signal and ensure compatibility with older Gigabit Ethernet transceivers If you find that your system does not function in STANDARD mode, change the mode to LEGACY...
-
Page 9: Specifications
Specifications 5900 Standards: IEEE 802.3z/AB 10/100Base-TX/FX Connector: Optical ONE SC or TWO STs’ (Single mode fiber recommended) Electrical One RJ-45 Max. Distance: Cat.5 twisted pair: up to 100m Optical fiber: 9/125um singlemode up to 10km Multimode operation is possible at substantially shorter distances. Contact the factory. CWDM and DFB optics are also available LED Indicators: FX Rx, FX Link, TX Tx, TX Link, FDX, PWR... -
Page 10: Warranty
A claim of defect in materials or workmanship in any Product shall be allowed only when it is submitted in writing to Telecast Fiber Systems, Inc. within seven days after discovery of the defect, and in any event within the Warranty Period.