JVC KD-LHX552 Service Manual page 15

QQ
3.2.4 Removing the clamper unit 3 7 63 1515 0
(See Figs.5 and 6)
• Remove the mechanism control board, top cover and mecha-
nism section.
(1) From the bottom side of the mechanism section, remove
the clamper 2 spring. (See Fig.5.)
(2) Release section e of the clamper spring from the bending
section of the CD chassis assembly. (See Fig.6.)
(3) Move the clamper unit 2 in the direction of the arrow and
release the joints (f, g). (See Fig.5.)
(4) Take out the clamper unit 2 in an upward direction. (See
Fig.5.)
3.2.5 Reattaching the clamper unit
(See Figs.5 to 9)
(1) From the bottom side of the mechanism section, attach the
clamper spring to the clamper unit 2. (See Figs.5 and 9.)
(2) Move the clamper unit 2 to set the joints (f, g) to each pro-
jection of the CD chassis assembly. (See Fig.5.)
(3) Make sure that section h of the clamper unit 2 is inserted to
the notch of the CD chassis assembly. (See Figs.5 and 8.)
(4) Move the clamper spring to the outside of the bending part
of the CD chassis assembly. (See Fig.6.)
Caution:
When reattaching the clamper unit 2, temporarily hook
the end of the clamper spring as shown in the figure to
make the work easy. (See Fig.9.)
(5) Attach the clamper 2 spring to the CD chassis assembly
and clamper unit 2. (See Figs.5 and 7.)
TE
L 13942296513
www
.
http://www.xiaoyu163.com
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
Clamper spring
f
Clamper 2 spring
Q Q
3 6 7 1 3 CD chassis assembly 1 5
Clamper spring
CD chassis assembly
co
.
9 4 2 8
Clamper unit 2
h
g
0 5 8 2 9 9 4 2 8
Fig.5
e
Fig.6
m
(No.MA152)1-15
9 9
9 9