Related Manuals for Dillenger Cheetah
Summary of Contents for Dillenger Cheetah
- Page 1 Cheetah Folding Bike Thank you for purchasing a Dillenger Cheetah Folding Bike, please read this manual before using this product.
-
Page 2: Table Of Contents
ABLE OF ONTENTS Assembly Instructions ............................. 3 Safety ..................................... 3 Taking Care Of Your Batteries ..........................4 Charging the battery ..............................5 Maintenance ................................6 Brake adjustment ..............................6 Front calliper brake adjustment: ..........................6 Rear brake adjustment: ..............................6 Fine brake adjustment (front and rear) ........................7 Motor Chain Tightening: ............................. -
Page 3: Assembly Instructions
4. The handlebars will already be assembled. The handlebars fold on an angle for easy collapsing of the Cheetah. The handlebar folding joint has a different mechanism to the main folding joint. 5. Attach the pedals using the 15mm spanner provided. Each pedal will only fit on its respective side; they are marked for easy installation either with a sticker on the pedal or embossed on the end of the threaded section. -
Page 4: Taking Care Of Your Batteries
AKING ATTERIES Charge the battery at least every 30 days Make sure the battery is fully charged (as indicated by status on charger) before use. Q: I HAVE HAD MY ELECTRIC BIKE A WHILE NOW AND IT’S NOT GOING AS FAR AS IT DID WHEN NEW, DOES THE BATTERY NEED REPLACING? –... -
Page 5: Charging The Battery
HARGING THE BATTERY The charger is provided with the Cheetah. 1. Do not use any other type of charger 2. Do not leave on charge for more than 12 hours 3. Do not leave a charging battery in the sun 4. -
Page 6: Maintenance
AINTENANCE RAKE ADJUSTMENT RONT CALLIPER BRAKE ADJUSTMENT For front brake adjustments, please see this video: http://www.youtube.com/watch?v=W1xcWoGlTdk EAR BRAKE ADJUSTMENT Loosen the main cable tensioning nut as shown in this photo (other model shown): Pulling the cable through in the direction of the arrow tightens the brakes. -
Page 7: Fine Brake Adjustment (Front And Rear)
INE BRAKE ADJUSTMENT FRONT AND REAR The fine brake adjustment is used to adjust the front and rear brakes as they are ‘run-in’ or to fine-tune the adjustment after adjusting the cable length as just described. This is how the mechanism looks when done up: The two silver nuts are used to tighten and loosen each braking cable. - Page 8 Once the adjustment has been made, retighten the larger nut in place so the adjustment doesn’t change while riding. Tips on brake adjustment: 1. For front or rear, start by screwing in the fine adjustment so both nuts are all the way in 2.
-
Page 9: Motor Chain Tightening
OTOR HAIN IGHTENING For tightening the motor driver chain independently, here is the procedure: If you look at the motor, you will see it is mounted to a metal plate that pivots at one end. That plate is held in place by a large vertical bolt that goes through the plate and holds the plate with a nut on either side of the plate (top and bottom). -
Page 13: Troubleshooting
These can be bent out of place if the battery is inserted incorrectly. Check that the battery has been fully charged If that solution does not work, report the fault to Dillenger and please let us know the following: Do the lights on the handlebar display illuminate? ...
Need help?
Do you have a question about the Cheetah and is the answer not in the manual?
Questions and answers