Connecting To Zio; Spi Pinmap - Zilogic Systems ZIO User Manual

ZIO, Motherboard User Manual
Chapter 2. Connecting to ZIO
In this chapter we will describe the connector used for the ZIO ports and the pins found on each
of the ports. The ZIO has 5 FRC connectors.
1. DIO
2. AIO
3. PWM
4. UART-I²C
5. SPI
1. SPI Pinmap
The SPI header is terminated with serial peripheral interface (SPI) bus, 4 general purpose IO
and power supply. Add-on boards with SPI interface and general purpose IOs like MMC/SD
card,EEPROM etc., can be connected through this header.
Table 2.1. SPI Header
Pin # Header Signal
1 VCC
2 SCK
3 MISO
4 MOSI
5 SS
6
DIO0
7 DIO1
8 DIO2
9 DIO3
10 GND
1
5V tolerant Input
2
Open collector, with 5V pull-up
VCC (Pin 1)
SCK (Pin 2)
MISO (Pin 3)
MOSI (Pin 4)
SS (Pin 5)
DIO (Pin 6-9)
Signal Type
+5V
TTL Out
TTL In
TTL Out
TTL Out
OC
OC
OC
OC
Ground
This is the +5V power supply for the external devices. The supply has a
total current limit of 200mA when powered through USB.
This is Serial Clock signal.
This is the Master Input, Slave Output signal.
This is the Master Output, Slave Input signal.
This is the SPI chip select signal.
These are digital input/output signals. These lines can be used to
interface any extra signals required for a SPI devices like SD Card, etc., or
Zilogic Systems
1
2
2
2
2
Rev. 2.0
Page 3