E-Medic Silence TP 2 User Manual page 24

TV1 Standard
TV2 Standard
Active LFP
Select the Active LFP Configuration.
No LVDS:VBIOS does not enable LVDS.
INT-LVDS:VBIOS enables LVDS driver by Integrated encoder.
SDV0 LVDS:VBIOS enables LVDS driver by SDV0.
USB Configuration
Legacy USB Support
Allows USB devices to be used in MS-DOS.
EHCI Hand-off
This is a workaround for 0Ses without EHCI hand-off support. The EHCI
ownership change should be claimed by EHCI driver.
USB transfer time-out
The time-out value for Control, Bulk, and Interrupt transfers.
Device reset time-out
USB mass storage device Start Unit command time-out.
Device power-up delay
Maximum time the device will take before it properly reports itself to the
HOST Controller.
'Auto' uses default value: for a Root port it is 100 ms, for a Hub port the
delay is taken from Hub descriptor.
F71869 Super IO Configuration
Serial Port 0 Configuration
Set Parameters of Serial Port 0 (COM A).
Serial Port 1 Configuration
Set Parameters of Serial Port 1 (COM B).
F71869 H/W Monitor
Monitor hardware status
Second Super IO Configuration
Serial Port 1 Configuration
Set Parameters of Serial Port 1 (COM C).
Serial Port 2 Configuration
Set Parameters of Serial Port 2 (COM D).
23