F E At U R E S - O P E R At I O N S; Technical Specifications; Remote Control; Operating Instructions - Sunbeam SCH8305 Series Instruction Leaflet

F E AT U R E S - O P E R AT I O N S

TECHNICAL SPECIFICATIONS

• Amps: 12.5
• Wattage: 1500W (+5% –10%)
• Working voltage: 120V AC/60Hz

REMOTE CONTROL

Your heater comes with a remote control, unpack the remote
control from box. This includes one lithium battery,
CR2025/3V. Please note this remote control will not work
through walls. Remove battery before discarding the remote.
NOTE: REMOVE THE PROTECTIVE COVER FROM THE BATTERY
PRIOR TO BEGINNING OPERATION.
Battery Replacement
1. Locate the battery compartment on the back of the
remote control handset. Insert a small object (such as a
pin or paper clip) into the hole of the battery cover lock
(see Figure 1) and slide out the battery cover.
Figure 1
B
A. Battery Cover Lock
B. Battery cover
2. Remove old battery.
3. Place new battery into battery compartment.
4. Slide battery compartment into the remote control
handset until the Battery Cover Lock is securely latched.
5. For your convenience, a remote control holder is
integrated into the back of the heater housing.
A
Insert pin here
NOTES:
• Remove the battery from the equipment when it is not
being used for an extended period of time.
• Remove the used battery promptly.
• Do not discard used batteries into household trash
containers. Contact your local government for disposal or
recycling practices in your area.

OPERATING INSTRUCTIONS

1. Carefully remove your heater from the box. Please save
the carton for off-season storage.
2. Place heater on a firm, level surface.
3. Plug heater into a standard outlet. Once plugged in, the
Power Light will illuminate.
NOTE: Avoid overloading your circuit by not using other high
wattage appliances in the same outlet. At 1500 watts, this
unit draws 12.5 Amps.
Mode Control
Press the Mode Button ( /Mode) on the control panel to
select your desired heat settings. Each press of the button will
cycle through the below settings and the selected setting will
appear on the LCD. To operate with the remote control, first
press the Power Button ( ) on the remote and then press
the Mode Button to cycle through the below settings:
HI - HIGH Heat
The heater will run continuously at 1500W.
LO - LOW Heat
The heater will run continuously at 750W.
Heat & $ave Setting
EC -
®
The heater will now cycle between high (at 1500W) and low
(at 750W) heat settings to provide heat.