Table of Contents
Advertisement
clean the capstan, trip the "ON-OFF" switch at
the rear of the receptable with your finger and
hold the swab against the rotating capstan .
IMPORTANT:
When tape player is not in use,
remove the cartridge and store it in a cool, dry
place out of direct sunlight . If the cartridge is
not removed, the radio may be inoperative and
possible roller damage to the tape unit could
occur.
MOBILE RADIO TRANSMITTERS
Mobile radio transmitting equipment is sub-
ject to Federal Communications Commission
regulations and must be installed by a qualified
radio technician . The specific installation instruc-
tions for radio transmitters will vary depend-
ing upon the radio equipment used . Mobile
telephone equipment installed by your local
telephone company, citizens band radios and
electronic garage door openers will not adversely
affect vehicle operation . In the event any other
type of mobile radio transmitter is to be installed,
further instructions are required so that vehicle
operation will not be adversely affected . Contact
GMC Truck & Coach Division, General Motors
Corporation, Technical
Service Department,
Pontiac, Michigan 48053 (or in Canada, contact
General Motors of Canada Limited, Product
Service Department, Oshawa, Ontario) .
Power Level System Controls
27
POWER LEVEL SYSTEM
The optional Power Level System provides
the ability to level the vehicle at campsite or
parking area where the ground is not level . This
system overrides the automatic leveling feature
that maintains a constant ride height at the rear
tandem suspension. The Power Level System can
raise or lower the rear of the vehicle approxi-
mately 4 inches from normal ride height .
The Power Level Controls are located to the
right of the steering wheel at the lower portion
of the dash panel .
NORMAL OPERATION
The controls consist of two knobs labeled :
"LEFT REAR" and "RIGHT REAR ." Each
knob has four positions and is used as follows :
"RAISE"-Knob in this position will raise rear
of vehicle to any desired level, up to a maximum
of 4 inches above normal ride height . When
desired height is reached, turn indicator on
knob to "HOLD" position .
"HOLD"-When indicator line on knob is turned
to this position the appropriate side of the vehi-
cle will remain at that height . This can be done
after being either in the "RAISE" or "LOWER"
position .
"LOWER"-With the indicator line in this posi-
tion the appropriate side of the vehicle will
lower a maximum of 4 inches below normal ride
height . In order to maintain a desired height
turn indicator on knob to "HOLD ."
Advertisement
Table of Contents
