Steering Column Controls; Anti-Theft Steering Column Lock; Parking; Starting Engine - GMC Motor Home Operating Manual

ANTI-THEFT STEERING
COLUMN LOCK
The anti-theft ignition switch, located on the
right side of the steering column, has five posi-
tions
B C D
A - CRUISE CONTROL ENGAGE BUTTON
B - TURN SIGNAL LEVER
C - TILT-AWAY STEERING WHEEL LEVER
D - IGNITION SWITCH
E - HORN BUTTON
F - HAZARD WARNING FLASHER BUTTON
G - TRANSMISSION SELECTOR LEVER
Steering Column Controls
Anti-Theft Steering Column Lock
STEERING COLUMN CONTROLS
1 4
ACCESSORY-Permits operation of elec-
trical accessories when the
engine is not running . To
engage, push key in and turn
toward you
(counterclock-
wise) .
LOCK
-Normal parking position,
locks ignition and provides
added theft protection by
preventing normal operation
of steering wheel and shift
controls . Key cannot be
turned to "LOCK" position
and removed until transmis-
sion is placed in "PARK ."
OFF -Permits turning engine off
without locking steering
wheel and shift controls .
RUN
-Normal operating position .
START
-Permits engagement of
starter .
NOTE: The anti-theft steering column lock is
not a substitute for the parking brake . Always
set the parking brake when leaving the driver's
seat unattended .
PARKING
When leaving the driver's seat unattended
SET PARKING BRAKE FIRST .
Place transmission selector lever in "PARK ."
Turn key to LOCK position .
Remove key from steering column lock (the
buzzer will remind you) .
Lock entrance door if leaving vehicle.
STARTING ENGINE
1 . Apply the parking brake .
2 . Place the transmission selector in "P" or
"N" ("P" is preferred) . A starter safety switch
is designed to prevent starter operation while
the transmission selector is in any drive position .
(If it is necessary to re-start the engine with the
vehicle moving, place the selector lever in "N".)
3. Depress accelerator pedal and activate
starter as outlined in the following, for different
conditions .