Canon Pixma Pro 9000 Mark II series Getting Started page 14

If the Found New Hardware or Found New
Hardware Wizard dialog box appears:
Windows needs to install driver sohwa:e for
yOL;r
senes
re
locate and install driver software (recommended)
Wirtdo ....s w;11 gUlde you tkrough the proceiis of IMtalling drn:er software-
tor,.'ourd~,(t
-+
Ask me again later
Wirdows will aiil:.lIgdltl the oext time fOU plug 'I' Jour deyice or log 00.
r
Don't show this message again for this device
Your d"'''ICe-Wlll not functIon until you ,,,stall drr-tH ;dt"'.'lrEc.
1
TURN OFF THE PRINTER (A).
2
Turn on the computer, then insert the Setup CD-
ROM into the CD-ROM drive.
The setup program should start automatically.
1
Remove the USB cable connected to
your computer.
The dialog box may close. In this case, proceed
from ,.
Windows Vista
Windows XP/2000
Go to Step
3.
Go to Step
5.
2
Click Cancel to quit the dialog box.
3
Proceed from ,.
• Make sure that the POWER lamp (8) has stopped
flashing and is off.
@!l _
• It takes about 1 minute until the printer turns off.
w _
• If the program does not start automatically, double-click
the CD-ROM icon on the computer. When the CD-ROM
contents appear, double-click MSETUP4.EXE.