Page 1
PS-18H/PS-19D/PS-20HA/PS-24H HYDRAULIC POWER UNIT OPERATOR'S MANUAL WITH MAINTENANCE AND PARTS INFORMATION 0 1 0 7 1-800-227-7515 P.O. BOX 840 LIVINGSTON, TEXAS 77351 PH# 936/327-3121 FAX# 936/327-4025 Web: www.littlebeaver.com E-Mail: sales@littlebeaver.com MFG. BY: LITTLE BEAVER, INC. - LIVINGSTON, TEXAS USA...
Page 2
Our hours are 8:00 am - 4:30 pm central time, Monday thru Friday. When ordering by mail or fax, include a description and LITTLE BEAVER part number for the items you are ordering, your return address, and payment or your authorization for COD shipment.
Page 3
1 YEAR LIMITED WARRANTY For 1 year from purchase, LITTLE BEAVER, INC. will replace for the original purchaser, free of charge, any part or parts, found upon examination by any factory authorized service center, or by the factory at Livingston, Texas, to be defective in material or workmanship or both.
LITTLE BEAVER, INC. does not recommend or condone any unauthorized modifications to the Hydraulic Power Source. LITTLE BEAVER, INC. reserves the right to make changes in design and changes for improvements upon its product without imposing any obligation upon itself to install the same upon its products theretofore manufactured.
MAINTENANCE AND LUBRICATION Engines are shipped without oil or gasoline. Refer to MANUFACTURER'S INSTRUCTIONS for proper procedures and recommended fluids. SHUT OFF ENGINE to adjust, service, clean or refuel the machine. HYDRAULIC RESERVOIR: The hydraulic reservoir should be filled to the "FULL" mark on the dipstick with recommended hydraulic oil.
BEFORE STARTING THE ENGINE, Be sure that: 1) Engine is properly prepared to Manufacturer's specifications. Refer to engine manufacturer's instructions. 2) Fuel valve is open. 3) Hydraulic fluid level is maintained properly. 4) Hydraulic flow valve lever is in "START/OFF" position. 5) Battery is properly charged.
Page 8
operating instructions, continued... HYDRAULIC FLOW BYPASS VALVE: The PS-18/19/20/24 hydraulic power source is equipped with a hydraulic flow bypass valve which diverts the hydraulic flow to the reservoir ("START/OFF" position), or to the pressure coupling ("ON" position). The hydraulic flow bypass valve allows tools to be coupled and uncoupled to the power source without shutting off the engine.
Page 9
CONNECTING TOOLS: Before connecting any tool to the hydraulic power source, make sure that it is compatible with the flow and pressure range of the power source. Also make certain that the relief valve setting, which determines the maximum pressure that the unit will apply to the tool, is properly adjusted. IMPORTANT: CHECK the flow direction of the tool.
Page 19
IMPORTANT: All nuts, fasteners, and fittings must be kept tightened. Refer to torque chart for proper assembly torque. TORQUE INFORMATION HEX HEAD SOCKET TYPE WRENCH SIZE WRENCH SIZE GRADE GRADE inch SIZE No. 4 8 in lb 12 in lb 1/4"...
Page 20
T T T T T H H H H H I I I I I N N N N N K K K K K S S S S S AFET AFET AFET Y Y Y Y Y AFET AFET FI FI FI FI FI RST! RST! RST!