Advertisement
These recommended actions do not guarantee that the receiver will work when
reassembled. If the receiver works, there is no guarantee that it will continue to do so for
a long period of time. However, the above actions will slow down or minimize corrosion
of circuitry.
If the receiver works, the customer may continue to use the unit. However, we
recommend that the receiver be returned to WMI as soon as possible for inspection.
WHEN A RECEIVER IS OPENED, THE SENSITIVITY AND CALIBRATION MAY BE
ALTERED.
If the receiver does not work, send it back to us for a repair estimate. Please include all
receiver parts in your shipment. Also include your phone number and a written
message that explains any unusual behavior and your actions to stop the behavior.
This information will help the technician to go quickly to the problem, saving time and
repair costs.
After your warranty has expired, a battery pack can be changed at home. (When
receiver is under warranty, we change the battery at our facility, then charge, retune, &
recalibrate to insure quality performance.)
INSTRUCTIONS:
1) Remove 4 screws (at left upper and lower edge of faceplate; at right upper and
lower edge of plate) from faceplate.
2) Lift only the faceplate off: grasp antenna jack and tilt right side of faceplate higher.
(DO NOT lift up the layers of circuit boards! The receiver is tightly packed with
components and you will have difficulty stuffing wires etc. back where they belong!
Shorted and burned wires can result.)
3) Battery pack is at right as you look into receiver. Unplug old battery pack. To get old
battery out, you may need to unscrew/loosen battery holder at right outside of box.
4) Plug new battery pack in, fit into battery holder and tighten outside screw as needed.
5) Fit faceplate on, lower left side first. Tighten screws at the four corners.
6) CHARGE BATTERY for 16 to 24 HOURS.
7) Test receiver; hopefully it will not need to be retuned or recalibrated.
VELCRO TO HOLD RECEIVER IN CASE
• With the receiver CASE, you'll find two strips of unattached Velcro that have plastic
backing.
• Please look inside the case at the bottom and back center. You'll find two
permanently attached Velcro strips.
• To protect your receiver, anchor the receiver to the case with Velcro.
--- Turn the receiver over. Peel the plastic backing off one loose strip. Place the strip at
bottom center of box. Rub to seal.
TO CHANGE BATTERY PACK:
Advertisement
