Advertisement
A. You will not be able to locate your dog's signal at its assigned frequency. To
center the Delta Tune knob,
1. Turn the Delta Tune and the Gain Control knobs down to low, with both
their white lines in matching positions.
2. Then tighten the screw at the side of the Delta Tune knob.
3. Return Gain knob to desired level.
4. Place Delta Tune line at 0 or center.
VII. If the Signal Meter Needle stays or "hangs" at the low end of the meter:
A. When the needle does not go down to 0, your readings will be off kilter. To
"zero the meter,"
1. TURN OFF POWER.
2. Place BAT/SIG switch on SIGnal.
3. With a small screwdriver, turn screw beneath signal meter until needle
centers on zero line.
VIII. If your receiver has gotten wet (by humidity, fog, rain, snow, dropping in pond,
etc.):
A. The signal meter needle sticks at the right side of the meter. The needle
stays up or "hangs" rather than coming down.
B. DO NOT OPERATE during this time. Turn power OFF.
C. Water damage may void your warranty.
D. If your receiver has been dampened by moisture:
1. Turn box upside down with lid open to form an inverted V.
2. Draw moisture out with a fan or blow dryer set on LOW. Dry by blowing
air through receiver from one end to another.
E. We prefer that you send the receiver to us immediately!
F. However, if water runs out of receiver when turned upside down, the circuit
boards have been drenched with water. It becomes important to minimize
damage as quickly as possible.
1. On receiver face, remove four corner screws, 2 from left side and 2
from right side. These screws are inside the rubber lip and nearest to the
lip. Use the screw just right of the AC Charger as guide.
2. Lift the entire receiver assembly from blue case. DO NOT TAKE THIS
ASSEMBLY APART! Leave 3 boards intact, with spacers between.
3. Disconnect the battery: pull apart white connector at right.
4. Turn on oven to 200 degrees, open door, and pull out bottom rack.
5. Put receiver assembly on rack so warm air will pass over it.
6. DO NOT PUT RECEIVER IN OVEN, even with door open.
7. After receiver assembly has dried, reassemble using new battery pack
($35.00). Receiver moisture usually harms battery, which then corrodes
and leaks onto circuit boards.
NOTE:
Advertisement
