Travis Industries Avalon Tree of Life GS2 Owner's Manual page 42

Optional Equipment
42
5 Remove and discard the NG air deflector. Attach the LP air deflector included with the stove. Note how the LP
deflector has a notch along the bottom.
NG Air Deflector
6 Install the LP pilot orifice following the instructions below.
(a) Use a 7/16" open-end wrench to remove the pilot hood.
(b) Remove and discard the Natural Gas (NG) orifice. Place the LP orifice in the pilot assembly then replace
the pilot hood, tightening the pilot hood until it is snug (do not over-tighten).
7 Replace the firebox components. Install the
logs and embers. Replace the glass.
8 Remove and discard the screws (see "a" below)
holding the stock regulator in place (see "b"
below). Remove the stock regulator and gasket
(see "c" below). Place the LP regulator in place,
making sure the pre-fitted gasket (see "c" below) is
in place. NOTE: There is a label on the base of
the regulator knob indicating regulator type (NG or
LP). Secure the regulator with the screws
included with the regulator – tighten to 25 lb-in of
torque. Place the included label on the valve body
where it can be easily seen to ensure proper
identification.
NOTE: Leak-test this area after the heater is
installed, gas is connected, and the main
burner is lit.
9 Make the gas line connection, bleed the gas line (if applicable), start the heater and thoroughly leak-test all gas
connections and the gas control valve.
© Travis Industries
Natural Gas Orifice = .020N (3way)
LP (Propane) Orifce = .014LP
a
7/16" Wrench
(for qualified installers only)
.020N
or
.018N (2way)
.018N
.014LP
a
b
d
4121128
LP Air Deflector
b
T-20 Torx or
Slotted Screwdriver
c
100-01313