Table of Contents
Advertisement
Available languages
Available languages
Basic Parts of the
Built-in and Portable
models
Side shelves not shown
Tools needed:
Gather the required tools and parts before
starting installation. Read and follow the
instructions provided with any tools listed.
• Level
• Phillips screwdriver
• tape measure or ruler
• slip joint pliers
• pipe wrench
• adjustable wrench
Parts needed:
• 1-1/2" drain system
• 1" drain system
• NSF- or UPC-listed water connection lines
• plumbers putty
• clear silicon
Installation -
Built-in model
WARNING
Excessive Weight Hazard
Use two or more people to move
and install bar cart.
Failure to do so can result in back
or other injury.
Use a certified plumber to connect and
install potable water supply and drain
system to outdoor bar cart per local code
requirements.
1.
Set the Bar Cart on a protective
surface such as cardboard or a blanket.
2.
Make sure you have the drain
connections, in accordance with local
codes, under the Bar Cart.
bottle well
holder
single
faucet
outlet hose and
sink
connectors
inlet hose and
connectors
water filter connection
and filter
3.
Remove the bottle rail, bottle cap
catch pan and water filter from the ice bin.
4.
Remove the faucet from the sink.
sink
washer
locknut
5.
Install the faucet and fasten
securely.
6.
Install the water filter on the
sink/faucet side of the cutout. Position the
filter so that the plastic hose attached to
the filter easily reaches the faucet
connection.
bottle well
bottle
1-1/2"
opener
drain fitting
towel
holder
plastic hose
connector
7.
Install water inlet connection in a
convenient location under the cutout.
Position the water inlet connection so that
the plastic hose easily reaches the filter
inlet connection.
plumbers putty
8.
Place a small amount of plumbers
putty around both the ice bin and sink
drain mounting seats.
two piece
sliding cover
support
frame
ice bin
1"
drain fitting
bottle
rail
bottle cap
catch pan
nut
inlet
connector
mounting
panel
3
Advertisement
Table of Contents
