Tools Needed; Parts Needed - KitchenAid KFBP102LSS Installation Instructions And Use And Care Manual

Basic Parts of the
models
Side shelves not shown
Tools needed:
Gather the required tools and parts before
starting installation. Read and follow the
instructions provided with any tools listed.
* Level
« Phillips screwdriver
* tape measure or ruler
« slip joint pliers
* pipe wrench
« adjustable wrench
Parts needed:
« 1-1/2" drain system
« 1" drain system
« NSF- or UPC-listed water connection lines
« plumbers putty
« clear silicon
Installation -
Built-in model
AWARNING
Excessive Weight Hazard
Use two or more people to move
and install bar cart.
Failure to do so can result in back
or other injury.
bottle well
holder
outlet hose and
connectors sink
inlet hose and
connectors =
SS
1-1/2"
; . drain fitting
water filter connection
and filter towel
holder
bottle
opener oe
two piece
sliding cover
Qe
support
frame
ice bin
,
drain fitting
bottle cap
CO catch pan
Use a certified plumber to connect and
install potable water supply and drain
system to outdoor bar cart per local code
requirements.
1 aw Set the Bar Cart on a protective
surface such as cardboard or a blanket.
2 a Make sure you have the drain
connections, in accordance with local
codes, under the Bar Cart.
3 # Remove the bottle rail, bottle cap
catch pan and waier filter from the ice bin.
4 a Remove the faucet from the sink.
sink
washer
locknut
5 a Install the faucet and fasten
securely.
6 # Install the water filter on the
sink/aucet side of the cutout. Position the
filter so that the plastic hose attached to
the filter easily reaches the faucet
connection.
plastic hose nut ;
connector inlet
connector
—— mounting
1 panel
a Install water inlet connection in a
convenient location under the cutout.
Position the water inlet connection so that
the plastic hose easily reaches the filter
inlet connection.
plumbers putty
8 a Place a small amount of plumbers
putty around both the ice bin and sink
drain mounting seats.