KitchenAid KFBP100LSS Installation Instructions And Use And Care Manual page 4

drain
9.
Install the 1" (2.5 cm) drain fitting
in the ice bin and the 1-1/2" (3.8 cm)
drain fitting in the sink. Tighten securely.
Remove and discard the excess plumbers
putty.
10.
Ice bin drain and sink drain
fittings to be connected to drain system in
accordance with local code requirements.
11.
Apply a bead of all weather
clear silicone on the under side of the
back and two sides of the top lip.
12.
Carefully position the Bar Cart
into the cut out. Immediately remove any
excess silicone.
filter
13.
Connect the plastic hose from
the water filter to the faucet connection
and tighten securely.
4
washer
locknut
14.
hose from the water inlet connection to
the inlet side of the filter. Use N.S.F. or
U.P.C.-listed water connection line for
water supply to inlet connector. Potable
water supply system to be connected to
inlet connector per local code
requirements.
15.
bottle cap catch pan. Position them over
the key-lock studs and slide down to lock
in place.
16.
apply clear
silicone
place into frame on top of the ice bin.
Installation -
Portable model
Excessive Weight Hazard
Use two or more people to move
and install bar cart.
Failure to do so can result in back
plastic or other injury.
hose
Use a certified plumber to connect and
install potable water supply and drain
system to outdoor bar cart per local code
requirements.
1.
Make sure you have adequate
drain connections for the Bar Cart.
plastic
hose
inlet
connector
filter
Attach the plastic cold water
Unwrap the bottle rail and
Unwrap the sliding cover and
WARNING
2.
Remove the bottle rail, bottle cap
catch pan and water filter from the ice bin.
3.
Remove the faucet from the sink.
sink
washer
locknut
4.
Install the faucet and fasten
securely.
plumbers putty
5.
Place a small amount of plumbers
putty around both the ice bin and sink
drain mounting seats.
drain
6.
Ice bin drain and sink drain fittings
to be connected to drain system in
accordance with local code requirements.
7.
Install the 1" (2.5 cm) drain fitting
in the ice bin and the 1-1/2" (3.8 cm)
drain fitting in the sink. Tighten securely.
Remove and discard the excess plumbers
putty.
washer
locknut