Turning Off The Power - Dukane 8958A User Manual

Displaying the picture (continued)
CAUTION ►If you wish to have a blank screen while the projector's lamp is
on, use one of methods below.
- Use the supplied lens cover.
- Use the BLANK function (see User's Manual - Operating Guide).
Taking any other action may cause the damage on the projector.
NOTE • The ASPECT button does not work when no proper signal is inputted.
• There may be some noise and/or the screen may fl icker for a moment when
an operation is made. This is not a malfunction.
• For the details of how to adjust the picture, please see User's Manual -
Operating Guide.

Turning off the power

1.
Press the STANDBY/ON button on the
projector or the remote control.
The message "Power off?" will appear
on the screen for about 5 seconds.
2.
Press the STANDBY/ON button again
while the message appears.
The projector lamp will go off, and the
POWER indicator will begin blinking in
orange. Then the POWER indicator will
stop blinking and light in steady orange
when the lamp cooling is complete.
3.
Attach the lens cover, after the POWER
indicator turns in steady orange.
Do not turn the projector on for about 10 minutes or more after turning it off.
Also, do not turn the projector off shortly after turning it on. Such operations might
cause the lamp to malfunction or shorten the lifetime of some parts including the lamp.
WARNING ►Do not touch around the lamp cover and the exhaust vents
during use or just after use, since it is too hot.
►Remove the power cord for complete separation. The power outlet should be
close to the projector and easily accessible.
NOTE • Please power off the projector after any connected devices are
powered off.
• This projector has the AUTO POWER OFF function that can make the projector
turn off automatically. For more information, please see User's Manual - Operating
Guide.
12
STANDBY/ON button
POWER indicator