Control Of Water Level In Tub - Electrolux Washing machine Service Manual

Washing machines with ewm 1000 plus electronic control system and “delta 3” display board
Hide thumbs Also See for Washing machine:
Table of Contents

Advertisement

Notes:
AF
indicates if antifoam function is active
FUCS antiunbalance function before spin phase
x
variable duration
In the diagrams the speed is indicated as rotations per minute and the time in seconds

6.16 Control of water level in tub

The water fill is carried out in two phases:
level fill: is controlled by the closure of 1
time fill: the duration is calculated by the electronic board to fill the correct quantity.
The different levels are determined by the model configuration and depend on the type of tub used.
Notes:
P1
time needed to 1
(*)
time water fills are variable and are calculated by the electronic board on the basis of the
delivery rate (see specific table)
T
time needed to heat the water to the set temperature
"
seconds
'
minutes
VAE
time needed to drain the water until the anti-boiling (safety heater) pressure switch goes to
"EMPTY"
Movement: this column shows the drum movements at low speed and during spin. (See paragraph "drum
movements")
The times of drain phases with spin cycle are indicative and do not take into consideration the
intervention of the antiunbalancing and antifoam devices.
SOI/DT 2005-07 dmm
st
level pressure switch in the FULL position
st
level water fill
33/59
599 37 22-15

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ewm 1000 plus

Table of Contents