How To Operate The Setup Mode - Wadia m330 media server Owner's Manual

How to Operate the Setup Mode

Your Wadia m330 has been factory configured for
default operating settings that will allow immediate
enjoyment of superb audio without the need for fur-
ther adjustments. If you wish to make changes to the
factory default settings, a Setup Feature is provided to
customize the operating settings using a PC Computer
(not supplied) and the m330 connected to a HD Moni-
tor/TV. Refer to the m330 Remote Control Illustra-
tion and Operation on page 13, while performing an
introduction into operating the Setup Mode, follow the
steps below.
1. Press the STANDBY/ON Push-button on the Front
Panel or press the (Power) Push-button on
the Remote Control to switch On the m330. The
LED above the STANDBY/ON Push-button will
illuminate. The m330 will go through a startup
initialization of which might take upwards of 1.5
minutes with the connected HD Monitor/TV indi-
cating the progress. Refer to figure 1.
2. When the initialization has completed, the opera-
tional screen will appear and in the upper left cor-
ner is the "Server IP Address: _ _ . _ _. ___. ___.
Write down the IP Address Number, as it will be
used in the next step. Refer to figure 2.
14
Note: If the "Server IP Address" number appears
3. Using a computer connected to the same network
as the m330, launch an Internet Web Browser
Application (such as Windows Internet Explorer).
Type in, on the "URL-Address line", the follow-
ing:
The IP Address Number written down in step 2
Then press enter on the computer keyboard. Refer to
figure 3. There are selection tabs located across the
Figure 1
top of the window (Server Settings, Display Settings,
Source Settings, Contents, Source Settings and Firm-
ware). Each of the tabs have subheadings with current
status information along with various setup options.
There are explanations located to the right of the vari-
ous options and settings.
4. Click on the "Firmware" Tab (located on the top
right side). The current running firmware version
IP Address location
Figure 2
as 0.0.0.0, the m330 was unable to obtain an
IP Address from the computer network. Power
down the m330, wait several minutes and then
Switch it back On. If the m330 is still unable
to obtain an IP Address, the default automatic
configuration setting (DHCP, Dynamic Host
Configuration Protocol) might have to be set
manually. Contact your Computer Dealer and/
or the manufacture of the computer/network
hardware for assistance.
HTTP://__.__.___.___/config
is displayed. When a firmware update is available,
click on the "Release Notes" button. A new win-
dow will appear containing addition information
about the update and how to proceed.
5. To exit out of the setup mode, first save any
changes made by clicking on the "Save Changes"
button and then close down the Internet Web
Browser Application.
6. Proceed to "How to Operate" starting on page 18,
or to switch Off the m330, press the STANDBY/
ON Push-button on the Front Panel or press the
(Power) Push-button on the Remote Control.
Figure 3