M330 Connections - Wadia m330 media server Owner's Manual

m330 Connections

The m330 has the ability to be remotely switched On/
Off from a Wadia Digital Decoder, Preamplifier or
A/V Control Center via the Trigger Control connec-
tion. The connection instructions below together with
the m330 Connection Diagram on the next page is
an example of a typical audio or audio/video system.
Your system may vary from this, however the actual
components would be connected in a similar manner.
For additional information refer to "Connector and
Cable Information" on page 4.
Trigger Control Connections:
1. Connect a Control Cable from the Digital De-
coder, Preamplifier or A/V Control Center Trigger
Out Jack to the TRIGGER IN Jack on the Wadia
m330 Media Server.
2. Optionally, connect a Control Cable from the
m330 Media Server TRIGGER OUT Jack to an-
other component.
3. Connect any additional components in a similar
manner, as outlined in steps 1 thru 3.
Digital Audio Connections:
4. Connect a Cable from the Wadia m330 Media
Server AUDIO OUTPUT SPDIF Optical output to
the Digital Optical 1 Input on the Digital Decoder,
Preamplifier or A/V Control Center.
Note: A Coaxial connection may be used instead of
the Optical Connection.
Digital Video Connections:
5. Connect a HDMI Cable between the HDMI Socket
on the Rear Panel of the m330 Media Server to a
HDMI Input Socket on the HD Monitor/TV.
Note: If the HD/Monitor/TV has a DVI Input
instead of a HDMI input, then connect a DVI
cable between the m330 and the HD/Monitor/
TV.
10
Network Connections:
6. Using a CAT 5/6 Ethernet Cable, connect the cable
from the Router to the NET (Network) connector
on the Rear Panel of the m330.
7. Optionally, Connect another CAT 5/6 Ethernet
Cable from the Computer (Network Connector) to
the Router.
Note: For additional information on Networks and
Network Connections refer to the documenta-
tion supplied with the Router and Computer.
AC Power Cords Connections:
8. Locate the plug at the end of the cable coming out
of the supplied AC/DC Power Supply and connect
it to the DC Input connector on the Rear Panel of
the m330 Media Server.
9. Connect the supplied AC Power Cord between the
socket on the AC/DC Power Supply and a live AC
outlet (that is always On).