Replacing The Rear Fan Assembly - Lenovo ThinkStation P500 Hardware Maintenance Manual

Replacing the rear fan assembly

Attention: Do not open your computer or attempt any repair before reading and understanding the Chapter
1 "Read this first: Important safety information" on page 1.
Note: Your computer might come with one or two rear fan assemblies. If your computer comes with two
rear fan assemblies, the following instructions apply to either of them.
To replace the rear fan assembly, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 111.
3. Remove the direct cooling air baffle. See "Removing and reinstalling the direct cooling air baffle" on
page 112.
4. Locate the rear fan assembly. See "Locating components" on page 32.
5. Disconnect the rear fan assembly cable from the rear fan connector on the system board.
Note: If your computer comes with two microprocessors, you might remove the heat sink and fan
assembly on the left side first for easier access to the rear fan connector. See "Replacing the heat
sink and fan assembly" on page 164.
6. Press the retaining clip attached to the edge of the computer rear panel to remove the rear fan assembly
as shown from the chassis.
Figure 97. Removing the rear fan assembly
7. Align the two tabs
chassis.
162
ThinkStation P500 and P700 Hardware Maintenance Manual
1
on the new rear fan assembly with the two corresponding slots in the computer