Prestige APSOE3B4SCF Programming Manual

Transmitter

The transmitters included with the system have been pre-programmed at the

factory, with each button pre-assigned to control a specific function of the

system. Some systems may have a 3, 4, or 5 channel RECEIVER, depending

on the model, the transmitters included with the system are 7 channel

transmitters. This allows you to program each transmitter to more than one

vehicle in two car families and also allows you to change which button or

buttons control certain functions of the system.

TRANSMITTER

CHANNEL BUTTONS CHANNEL

* Remote Panic/Car inder is available only on certain models.

* Door Lock/Unlock may require additional components in certain vehicles.

AS 9075 Remote Car Starter

AS 9256 Remote Trunk Release Relay

AS 9154 Remote Garage Door Interface

AS 9153 Remote Window Roll Up

Transmitter Programming Guide

APSOE3B4SCF

Model :

SYSTEM RECEIVER

FUNCTION

Remote Arm

*Remote Panic/Car Finder

*Remote Door Lock

Remote Disarm

*Remote Panic/Car Finder

*Remote Door Unlock

Remote Trunk Release/Remote Start

128-7768

1 of 4

Table of Contents

Do you have a question about the APSOE3B4SCF and is the answer not in the manual?

Page 1 Transmitter Programming Guide APSOE3B4SCF Model : The transmitters included with the system have been pre-programmed at the factory, with each button pre-assigned to control a specific function of the system. Some systems may have a 3, 4, or 5 channel RECEIVER, depending on the model, the transmitters included with the system are 7 channel transmitters.
Page 2: Programming Transmitters
PROGRAMMING TRANSMITTERS: It is important to remember that during programming, each individual step of the procedure must be executed within 15 seconds of the previous step. When the 15 second time limit is allowed to expire, the system will automatically exit program mode.
Page 3: Battery Replacement
8. The dash mounted LED will flash 3 times, and the siren will "chirp" 3 times, indicating that the system is ready to accept programming for channel 3. Remote Start & or Trunk Release Output, (where so equipped). 9. (a) Press and hold the Trunk/Key button on your keychain transmitter until the siren emits a long chirp tone.
Page 4 ORDER FORM FOR APSOE3B4SCF TRANSMITTER IMPORTANT: To help us expedite your order, please print all of the information legibly, and mail this form and your payment according to the instructions below. Please indicate which button pad is used with your transmitter as indicated above. __________ Please indicate transmitter model number as found on back of case.