Prestige 3BCR Programming Manual

The APS-995 Model has a configurable receiver that allows the transmitter
to be programmed to operate the Lock/Unlock functions with one transmitter
button or with two transmitter buttons (separate Lock/Unlock). In addition,
the receiver also allows driver priority function. This driver priority function
takes place when ever a particular transmitter is used to unlock the vehicle
regardless of the selection of one button or two button operation.
The following indicates the receiver programmable slots.
1 Lock/Unlock or Lock
2 Unlock if Programmed
3 Trunk Release & or Remote Start (Optional on some models)
4 Auxiliary Output
5 Auxiliary Output
6 Driver 1Priority or Separate Output
7 Driver 2 Priority or Separate Output
Receiver channels 6 or 7 will accept the programming of transmitter
channel 1 if used as the Lock/Unlock button, or Channel 2 when separate
Lock/Unlock buttons are programmed. In this way, whenever the transmit-
ter is used to unlock the vehicle, channel 6 or 7, when programmed, will
provide a pulsed ground output. This output can be connecter to the driver
priority function of the vehicle to reset preset user features. Please consult
with your installation centers technician to see if this feature is available in
your vehicle.
Note: A total of 4 transmitters may be programmed into any receiver
channel.
Force programming a transmitter, removing a transmitter, or reprioritizing a
transmitter is covered later in this manual.
Also, if you do not program a transmitter button into channel 2 which is the
separate unlock/disarm channel, then whatever button is programmed into
channel 1 will serve as both lock/arm & unlock/disarm.
Note: The RED Button serves as a function button in combination with other
buttons explained in your owners manual. This button may not be used to
operate a receiver channel.
TO ENTER THE PROGRAM MODE:
1 Turn the ignition switch to the "ON" position.
2 Within 10 seconds, Press and release the valet/program switch three
times.
(Siren emits 1 short chirp indicating channel 1 has been entered)
3 Within 10 Seconds, Press and hold the button of the first transmitter you
wish to control the Lock & Arm feature of your security system until a long
chirp is heard from the siren.
Released: 09-25-01
Placed document number on last page. Did not rev document 01-09-07.
Model 3BCR
Programming Guide
128-6164
1 of 6