Basic Troubleshooting; Diagnostic Fault Codes - Pride Pursuit Owner's Manual

V I I I . B A S I C T R O U B L E S H O O T I N G
Any electromechanical device occasionally requires some troubleshooting. However, most of the prob-
lems that may arise can usually be solved with a bit of thought and common sense. Many of these problems
occur because the batteries are not fully charged or because the batteries are worn down and can no longer
hold a charge.

DIAGNOSTIC FAULT CODES

The diagnostic fault codes for your scooter are designed to help you perform basic troubleshooting quickly
and easily. A diagnostic flash code will flash from the status LED in the event one of the conditions listed
below develops.
NOTE: Your scooter will not run unless the fault code condition is resolved and the scooter has been
turned off, then turned back on.
FAULT CODE
(1)
(2)
(3)
(4)
(5)
What if all the systems on my scooter seem to be dead?
Make certain that the key is in the "on" position.
Check that the batteries are fully charged.
Push in the main circuit breaker reset button. See III. "Your Scooter."
Make certain that both battery harnesses and the front-to-rear harness are firmly connected. See VII.
"Disassembly and Assembly."
Be sure the power down timer feature has not been activated. See V. "Operation."
Pursuit
CONDITION
Battery charge is low.
Battery charge is too low.
The scooter's battery voltage is too
high to operate the scooter, or the
charger is still connected to the off-
board charger port.
Current limit time out.
The manual freewheel lever is in the
(forward) freewheel position.
(6) Throttle control lever not at center
position at start up.
(7) Speed pot error.
Motor volts error.
(8)
(9) Other internal errors.
www.pridemobility.com
SOLUTION
Charge batteries as soon as possible.
Charge batteries.
Unplug charger and/or turn key off,
then back on again.
Turn the scooter off for a few min-
utes, then turn your scooter back on.
Remove the key from the key
switch, then push the manual free-
wheel lever to the drive (rearward)
position and restart your scooter.
Return the throttle control lever to
center position, turn scooter off then
back on.
Call your authorized Pride Provider for
assistance.
Call your authorized Pride Provider for
assistance.
Call your authorized Pride Provider for
assistance.
35