Advertisement
I
N
S
T
A
L
L
A
T
I
O
N
I
N
S
T
A
L
L
A
T
I
O
N
This appliance must be installed by an authorised person.
1. The SunPhase heater is to be securely fixed to the wall by means of the
wall plate and mounting bracket. There are 4 bolt holes in the mounting
bracket. The heater weighs 5kg. The mounting bracket fixed to the
heater must not be modified in any way.
2. For fixing to a wall remove the wall plate from the mounting bracket as
detailed below:
Parasol Heaters Australia ‐ 61 3 9549 4466
Created on 12/08/2009 11:58:24 PM
I
N
S
T
R
U
C
T
I
O
N
I
N
S
T
R
U
C
T
I
O
N
Undo the nut on the J bolt and then
The bolt will slide out and then the
Securely attach the wall plate to the
When replacing the 'J' Bolt ensure
If the heater is being fitted with an
S
S
remove the bolt.
wall plate can be taken away from the
heater.
wall, ensuring it is to the horizontal.
the bolt is pushed fully into the holes
and that the heater is at the desired
tilt angle. Replace the nut.
outer case kit the angle must be 30
degrees which is the maximum down
tilt. This is the factory set position.
Installation/Operating Instructions
Page 8 of 11
Advertisement
