Configuration - Network - Kentix MultiSensor-LAN User Manual

Navigation
Home! ! !
Login! ! !
Configuration
! Network!
! Sensors!
System!! !
Logbook! !
Help ! ! !
Logout! ! !
Configuration - Network
IP address / network mask / gateway
Network configuration of the MultiSensor.
If you need the MAC address of the MultiSensor for your router or firewall settings, you will find it on the
network jack when opening the device.
DNS1/2 (Domain Name Server Addresses)
Enter the name server address. Depending on network configuration e.g. on use of an ADSL router it can be
the gateway address.
NTP1/2
Configuration of the time server (network time protocol). The NTP configuration is needed if you use the
time-controlled arming and disarming. The time is displayed as UTC time on the homepage.
IP-address and activation of AlarmManager communication
Activate the communication with the Kentix AlarmManager here.
Enter the IP-address of the AlarmManager and set the hook.
FTP server activation
The integrated FTP server can be activated or deactivated. The FTP access will be needed for a software
update of the device. Look up in the chapter „software update" for it.
E-Mail
If the MultiSensor should be able to send e-mails in the case of alarm to a configured user, it is necessarry to
set an e-mail server (SMTP or ESMTP). When you have set a DNS server, which is configured in the DNS
settings, you can use the DNS name of the e-mail server here. With using ESMTP you can here enter the e-
mail access data, which you can obtain from your e-mail provider. Pay attention that many mail servers need
an existing sender address to send an e-mail correctly.
In the subject of the e-mail the corresponding alarm text can be found and in the mail text all measurements
from the MultiSensor are included.
SNMP settings
Configuration of the Simple Network Management Protocols. The MultiSensor-LAN is able to send alarm
messages as SNMP-Traps. Enter both SNMP host addresses for this. Further the sensor can be prompted
or partially configured via SNMP. The functions which are available for the SNMP communication are
specified in the supplied MIB (Management Information Base). It is available on the integrated FTP server or
as download from the Kentix website.
Page 6
- Starting page with the measurements overview
- User login
- Communications setup
- Sensor- and Alarm setup
- System information (software version) and device RESET
- Command for support purposes
- Help and support information
- User logout
Public DNS servers: 192.25.2.129 or 194.25.2.130
Public NTP servers: 129.69.1.153 or 130.149.17.21
!
(09-2012, subject to change)!
www.kentix.de